0

I'm running a cold-water pex line in a basement crawlspace that gets extremely cold (i.e. freezing) in the winter.

I'm going to use a drainable ball-valve inside the house so I can drain it in the winter but how can I run the pex line to make sure it's sloped? The run is about 25 feet long.

I think I have two options:

1) Run it through floor joists (requires a hole in every joist since my line is running perpendicular to them)

2) Run it under the joists and use clamps and wood shims under each joist to achieve a slope.

I'm leaning towards #1 but to make sure I have a good slope I think I'll need to measure my holes to make sure the line is actually sloping. For example, I thought I would measure a certain distance from the joist to the floor above to make sure my holes are actually sloping down.

Any other suggestions?

(NOTE: This question is sort-of a follow-up to this: Do I need to angle/pitch pex tubing for draining in the winter?)

Thanks!

  • 1
    another suggestion: add a valve to allow you to blow it out. – Steven May 11 '16 at 16:35
1

If you have an air compressor you can plumb in a connector for an air line after the shuttoff valve for the line.

Then leave the faucet open at the end of the line and connect the air compressor with a pressurized tank. This will blow out the line and prevent freezing.

Good luck!

  • Thanks! Is there Sharkbite fitting I can use for this or something else? Also, how powerful of an air compressor do I need? (I suppose this is a good reason to buy one!) – SofaKng May 12 '16 at 2:14
  • Also, if I plan on doing this then do I even need to worry about the slope of the line or anything else freezing? – SofaKng May 12 '16 at 2:23
  • If you use air to blow the line you can ignore the slope since you won't be using gravity to drain it. A 2-3 gallon nailer compressor works just fine. A small tire inflating compressor doesn't. You have to create your own fitting and isolation valve for the air compressor input. – ArchonOSX May 12 '16 at 16:33

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.