I have a couple of outdoor light sockets with built in motion detectors. These seem to work as you'd expect with regular incandescent bulbs- you can set a timer for how long you want them to be on when motion is detected and they light up fine.
When replacing them with LED bulbs however they blink rapidly instead of staying on. I'm not talking about a 50hz buzz or whatever, they completely power off and on rapidly, almost like they are trying to strobe. The blinking is erratic, it will go for 10 seconds then go dark completely, then blink again for varying amounts of time. I see this same behavior with LED bulbs in both of the sockets, which are the same brand and model of motion detector outdoor light sockets.
The bulbs are Verbatim A19 6-Pack Warm White 3000K LED Bulb, Replaces 60W, Non-Dimmable 99072 if that matters.
I want to replace everything in the house with LED, but not sure how to make these two sockets work correctly. Suggestions?