I should have worn gloves but sadly I didn't. Now I have yellow stuff all over my hands. I got most of the stickiness to go away by using WD-40. Is there anything that will get this off without giving me chemical burns?
I tried paint thinner, acetone, alcohol, mechanics hand scrub, WD-40, Goo Gone, hand sanitizer, dish soap, course hand wipes, makeup remover, etc. the only thing that got most of mine off after it had cured was soaking in hot water until hands softened, and then scrubbed with a pumice stone. It got most of it off!
I was wearing flimsy gloves and somehow ended up with it on my hands anyway. What worked for me was a bit of Windex (I used that on my floor when some fell there and nothing else would clean it off), then a soapy handwash in room temperature water followed by a blob (really rubbed in well into my fingers and hands) of my Anti-bacterial Deep Cleansing Hand Sanitizer from Bath & Body Works. It worked! My hands are dry as dust, but I got it off. I did all of this within 15 minutes of it happening so I don't know the results if it sets for a while.
Yes, I knew better and it happened to me. If it has not cured WD-40 will work, which is what caused the problem for me. I got some on my hands took it off with WD-40, which gave me confidence I could get it off.
After it cures nothing works. It is no miracle, but it does speed the process up. If it is only a little, it will work well. Lotion, Lotion, Lotion, so much lotion your hands turn to prunes, like I said it is no miracle, but does speed it up.
After foam has dried on hands, hydrate hands in warm to hot water for approximately three to five minutes (simpler done while bathing in tub) use a cheap (dollar store) disposal razor and of course carefully shave (soap not necessary) the foam off--take note this is done by way of feel as in shaving one's face.
Old question I know, but I use the Great Stuff Pro commercial foam gun that takes the inverted cartridge cans. They sell a cleaner for the guns that you mount on the gun just like the foam and spray the cleaner through until it runs clear. The cleaner also comes with a spray cap that you can spray down the outside of the gun. Well.....this stuff literally melts the foam away. It is amazing, and works on hands or anything else. Yes, it is a harsh chemical, but just wash your hands immediately after and put on some lotion. I've done this many times and never had even the slightest bad reaction. https://www.amazon.com/GREAT-STUFF-Dispensing-Cleaner-12oz/dp/B0002YWRG4
Naturally, like everybody else, I was not going to get any on my hands...but ended up with it on my fingers and palms on both hands. I tried various solvents to no avail. I was taking a shower, and I saw this gizmo (looks like a cheese grater) that I think my wife uses on corns and calluses on her feet. I lathered up and started scraping it off. Most of it was removed and no one would notice that I was an idiot.
After my mother picked pieces of her skin off, used olive oil method with commercial degresser, and acetone, hand sanitizer (bath and body works Stress relief!), rubbing alcohol, gasoline, and plain soap and water. She accidently came upon orange glo furniture 2 in 1 polish.....it took it off. Like a miracle, still have to pick up goof off but did well.
A lot of mechanics use Orange-based hand cleaners. Home depot has one:
Unfortunately I am the type of personality that cant seem to remember that if you don't put the toilet seat up you'll probably get P on the toilet seat. Point being I have gotten the stuff on my skin, sometimes in copious amounts,probably 15 times in my life. Nothing has worked well except for the last few times: semi course sandpaper and soap and water worked surprisingly better compared to solvents. Your probably filling in drywall so you probably have sandpaper around. Note: when you begin to sand your skin, you're done! you have gotten most of it off.
Get a stanley knife,,,,,,, i know this sounds dumb but hear me out!!! When the glue, foam, anything polyuretane will harden.... so if and ONLY if it has dried then scrape it off with a stanley knife... at about 45° angle and it will start cracking off like when you scrape paint off metal.. keep going as desired but NEVER USE JUST A BLADE........ YOU WILL SERIOUSLY INJURE YOURSELF
When I first tried to get it off, I tried dawn and water but it didn't help...so I used a kleenex to stick to my skin so it would at least stop being sticky....after about 30 minutes, it was easy to peel off the parts with the tissue- like a thick bandaid.
However, the tissue didnt stick to ALL the gunk, so as advised on this site, I used 100% pure Olive oil directly on a green scrubby coarse dish scrubby thingie, and, although it took time and lots of scrub scrubbing, it took off most of the great stuff residue gunk and all of the icky sticky feel the great stuff left behind. Finally, i used a hefty helping of Dawn to get the oil off. Best part? My skin was never rubbed raw or red! There is still a bit of residue left on my hands, and my hands are super dry, but lotion will fix that right up!
Conclusion: 1st, use kleenex so it sticks to the sticky parts and it will create a bandaid like substance that is easy to peel off in 30 minutes. 2nd, wait those 30 minutes, and then have fun peeling the kleenex parts off while reminiscing about middle school. 3rd, use 100% olive oil on a scrubby pad and scrub scrub scrub. 4th, use Dawn to wash off the oil. Finally, apply your go to hand lotion until your hands feel moisturized and renewed!
I managed to get alot of great stuff on my hands. This is what works with out chemicals. First, it was fully cured on my hands, dried with I minutes. I soaked and scrubbed hands in warm soapy water using regular hand soap. Got some of it off but it was on thick. Ran to store bought a pumice stone, two sided, course AND medium. Went home, soaked hands again and started to use pumice stone. Got some more off. Let hands dry a few minutes, repeating process several times and almost completely removed great stuff from hand and fingers. Moisturize after or hands will dry up.
I tried most of the suggested solutions and just made my hands hurts. Decided to just let it wear off. Took a shower and afterward used some leave-in hair conditioner and VOILA! it loosened the spray foam on my hands when I squeezed some out of the bottle to put on my hair. Softened it and I was able to peel it right off. Terrific. Try it!