2

I'm new to building or destroying things in that occasion.

I have a wall that is not supporting the roof or any other part of the house.

Removing that wall will help me build an extension of a room in my house.

I want to use a mace sledgehammer to destroy that wall.

Are there a better solution less consuming in time and effort than use a mace sledgehammer, please?

Second question is : Are there other factors should I check when trying to remove a wall in my house than checking the wall is supporting part of the roof?

Any of your advices would be welcome.

Cheers.

Improve this question
9
  • 2
    How do you know it's not supporting anything? Any possibility of plumbing or electrical in the wall?
    – CoAstroGeek
    Oct 7, 2015 at 20:59
  • Hi, no nothing. I thought it was supporting something actually it is a useless wall
    – Andy K
    Oct 7, 2015 at 21:04
  • 3
    If you're sure the wall is not load bearing, and there's not electric, plumbing, or ducting in the wall. Then go at it with the mace. You'll likely have quite a mess to clean up, but it will probably be enough fun to make up for it.
    – Tester101
    Oct 7, 2015 at 21:20
  • 2
    A mace (sledgehammer) would surely make a lot of small debris to pick up. My demo tools are reciprocating saw, 20 oz curved claw hammer, crow bar and short ripping bar. Everything comes down in large chunks, big enough to be a lot to carry. Small debris is at a minimum.
    – Jack
    Oct 7, 2015 at 21:38
  • 1
    By the way, I'm picturing you swinging something like this at the wall.
    – Tester101
    Oct 8, 2015 at 1:54

1 Answer 1

Reset to default
3

Brick Walls are usually load bearing or non-load bearing. Generally you can identify them by their width. While not "best practice", in some cases a connecting non-load bearing wall may act as a lateral brace to a long load bearing wall. This may be an issue in an earth-quake prone area where bracing walls are very important. Check with your local building codes for that.

Other than that, make sure you disconnect/reroute all services that run through- and inside and then demolish away. You may want to perforate the wall first, by either cutting it or drilling holes, especially where you want to disconnect the wall from the building.

The impact of a sledgehammer might cause unwanted superficial damage outside the area you are busy demolishing. Perforating and then using a crow bar/ripping bar may be a better solution.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.