2

Cack handed DIY amateur here.. I need to cut engineered wood planks lengthwise - they're 4mm oak on a 10mm MDF base. I'm having trouble getting a jigsaw to cut straight. With a "clean wood" blade the jigsaw almost immediately starts bouncing up and down vertically, even with a tight hold on the saw it feels like it's about to fly off. With a standard wood blade the saw stays down, but the cut veers off to the right in a banana shape. I've tried clamping another piece of wood to the top to steer the runner against and clamping the whole thing to a table, but it doesn't seem to help. I'd be grateful for any advice. Am I using the wrong tool maybe?

  • Wider jigsaw blades are less prone to bending. – Wayfaring Stranger Sep 3 '15 at 22:28
  • Also see: diy.stackexchange.com/questions/51300/… – Ecnerwal Sep 4 '15 at 2:30
  • If this is flooring, the core is probably Hdf (high density fiberboard), which is rough on all saw blades. If you're stuck with a jigsaw, you might try a blade specially designed for flooring. (Just an example -- not one I've used -- Bosch T101BIF.) – Aloysius Defenestrate Sep 4 '15 at 4:26
3

You are, IME, IMHO, using the wrong tool, definitely.

  • A (sharp) hand ripsaw would be preferable.
  • A circular saw would be preferable.
  • A bandsaw would be preferable.
  • A tablesaw would be ideal

...but a circular saw is far less expensive than a tablesaw and still pretty capable with a rip guide.

  • Hire a table saw from a local tool hire firm. You will not regret the quality of finish it gives on the flooring panels. – TravisPUK Sep 5 '15 at 9:19

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.