I'm looking to attach rock rings to my garage ceiling. I've found similar posts, but in each one, they have a seemingly critical difference from my setup:

  • I don't have access to above the joist because my living room is above my garage (here).
  • I have I-beams, not 2x8s (here, and seemingly here).
  • I have drywall covering my I-beams (here) but would prefer to leave it.

I do like bcworkz's answer but I'm not sure if this is something I can do with I-beams. I would think that lag bolting along an I-beam would be bad due to its thin profile. Perhaps this concept could be adapted with opposing angled bolts to better catch the beam?

Are there other options/variants for attaching to I-beams behind drywall?


If you don't mind the look, I'd suggest a 2x6 run perpendicular to your joists. Ideally, you'd get 3 joists (so a 2x6 slightly longer than 4', assuming you've got 16" spacing) with at least 2 good 3.5" #10 screws each. (Since these are pretty big screws, you'll want to drill pilot and clearance holes.) To attach the rock rings, use 6/7mm -ish cord through holes you've drilled in the 2x6. (If you don't want to dent the drywall, just chisel a small channel across the top of the holes.)

  • I don't mind the look at all, and that's similar to what I was thinking. Where exactly am I aiming for with the screws? Right threw the middle of the I-beam? I assume attaching it to the top and bottom bits of the beam (not sure what that's called) is less sturdy? Apr 13 '15 at 1:13
  • Aim for the middle of the flange (bottom/top bit). If you hit the web (upright section in the middle of the i-beam), it won't hurt. If you're too far off the middle, you run the risk of losing screw strength because of splitting. Apr 13 '15 at 1:44
  • I'd use a few more screws than that, or lags if I was doing it for someone else.
    – Mazura
    Apr 13 '15 at 2:59
  • Lags are totally doable, but I was curious how to accurately hit the middle of the I-beam with a lag, or am I still just aiming for the flange with the lag? Apr 13 '15 at 22:56
  • 1
    Whether lags or screws, just aim for the middle of the flange. Generally speaking, there's no holding power in the web, so don't feel like you need to bury a fastener in it. Apr 13 '15 at 23:55

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.