2

I want to make my whole house surge protected, there are several solutions available

  1. You can install MOV based surge protection on the entire house in line entry point - first line of defense
  2. You can use socket surge protection, MOV based as well - third defense line, protecting individual appliance
  3. Junction box SPD if such a thing exists - second line of defense.


How much of such defensive layers of surge protection makes sense to install from economical and technical point of view?

Improve this question
9
  • I don't know if layers are as important as the overall ability to absorb energy (usually measured in kA). Redundancy may be another issue altogether.
    – BrownRedHawk
    Mar 9, 2015 at 20:47
  • 3 levels of redundancy? it is not military application :) As I understand, once the energy cannot be absorbed you get catastrophic failure in MOV or anywhere else in SPD and your appliances are safe. but the line will be in unusable state until you replace the SPD, so where the redundancy matters here?
    – kreuzerkrieg
    Mar 9, 2015 at 20:54
  • It's possible for the MOV to fail open, so you'd be unprotected without another level of protection.
    – Johnny
    Mar 9, 2015 at 21:28
  • This may shed some light; nothing really deals with a direct strike. diy.stackexchange.com/questions/51897/…
    – Ecnerwal
    Mar 9, 2015 at 23:36
  • economical/technical point of view? That depends on the value of items you need to protect, the likely hood of surges and the amount of insurance coverage you have. If you have something that can not be lost, I would consider a dedicated offsite/offline backup first. As a surge is only one of many ways that data loss can happen.
    – diceless
    Mar 10, 2015 at 4:49

1 Answer 1

Reset to default
2

Before you even start on surge protection, look at your service entrance ground and consider adding to it if it's inadequate by current standards (it may well have been adequate by code when it was built, and still be underbuilt by current standards.)

For instance, if there's a single ground rod, you might consider adding 1, 2 or even 3 more spaced 8-10 feet apart. An effective ground is the backbone on which anything else you do to deal with surges rests - if it's not good, nothing else will work very well.

The answer I linked in the comment explains pretty much what I do, which is a somewhat layered approach. I guess I can link it again here. What does a surge protector do that a breaker doesn't?

The version of "whole house" protection I use is not a "plugs into the panel like a set of breakers" thing, so you could run a second set in a (preferably steel) junction box closer to the end-use point if you wanted to. I think they fit inside a 6x6x4 box.

Improve this answer
1
  • Looks like the MOV/SOV combination would provide best solution, am I right?
    – kreuzerkrieg
    Mar 10, 2015 at 5:31

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.