4

I've read many posts on this, and believe I know what to do, but want to make sure. My furnace (a Lennox G14 Series) does not have a C terminal which needs to be connected to the C terminal in my new wifi thermostat. In the attached picture of the terminal strip in the furnace, the red wire on the T terminal and the white wire on the Y terminal go to the air conditioner. The other 4 wires go to the thermostat. I've measure across the R and T terminals and get 28vac. Based on this I believe I can use the T terminal for the C connection...is that right?

Eventually I'll run a 5 wire cable but for now I plan on stealing the green wire to make the C connection if I can use the T terminal.

furnaceterminals

wiring

UPDATE: I've added the wiring diagram from inside the furnace.

3

Note: the solution here is the querent's -- I'm simply writing it up in a CW answer to get this off our plate as the querent has not returned to migrate it from his question-edits to an answer himself.


SOLVED (01/04/15): I decided that the T terminal was exactly what I needed so gave it a try and everything is working perfectly. I also pulled in some 18-5 thermostat wire. Here is my setup, in case it might help someone else:

Furnace: Lennox G14Q3-60-13

Thermostat: Honeywell RTH6500WF

I've attached pictures of my connections.

enter image description here

enter image description here

0

R wire is power supply hot C wire is power supply common W wire is furnace heat ignition relay (heat) G wire is furnace fan on/off (heat) Y wire is air conditioner fan on/off (cool)

if using an air conditioning compressor unit, add 1 wire from furnace terminal block label Y to the a/c compressor relay hot, add 1 wire from furnace terminal block label T to the a/c compressor relay common

Lennox terminal block inside the furnace uses T label on the terminal block for common, as shown in your electrical wiring diagram.

Older thermostats did not need a constant source of power for the thermostat display, so the C wire was typically not used.

Modern thermostats which have backlit displays, wifi etc., require a constant source of power and therefore require the C wire to be connected to the power supply in the furnace terminal block, to allow the flow of constant power to the thermostat.

Thermostat C Wire: Everything you need to know about the “common” wire

Don't waste your time calling Lennox customer service, it is a call center whose only mission is to send a repair technician to your home.

protected by Community Oct 8 '17 at 19:01

Thank you for your interest in this question. Because it has attracted low-quality or spam answers that had to be removed, posting an answer now requires 10 reputation on this site (the association bonus does not count).

Would you like to answer one of these unanswered questions instead?

Not the answer you're looking for? Browse other questions tagged or ask your own question.