I want to ceiling mount my projector using this projector ceiling mount. However I realize my ceiling beams are too thin to receive the 4 screws necessary to attach it.
The only way would be, not to install it so that the square of the mount basis be parallel to the projection screen, but rather diagonally with an angle of 45 degrees (so that one of the 4 square corners directly faces the projection screen). In that scenario the mount would be attached to the ceiling with only 2 screws.
Note that the mount + the projector together weight about 4 kilos. The screws are 1cm in diameter, 5cm deep.
What do you think? Risky? Acceptable?