2

I would like to put a smoke detector in my attached garage and barn, with a wireless/remote signal with a a receiver inside the house.

So far I have found this one

enter image description here

I am assuming that with that one, you buy some number of them (maybe 2 or 3 in my case) and they all broadcast to each other?

Are there any other similar products that you have experience using?

5
  • 2
    I would not recommend installation of a smoke dector in the garage or the barn. Smoke detectors monitor particles in the air and could be set off by vehicle exhaust or dust. A heat detector would best be used for applicaitons in a garge or barn. – RSMoser Jan 19 '11 at 18:55
  • Thanks. One issue is that it could get quite cold out there (well below freezing certain times of the year, like right now actually!)... I wonder if that affects the smoke detector in any way... hmm... The "garage" part is partitioned from the main barn area, so I wouldn't normally have to worry about car exhaust, but it could be an issue under some conditions or if I bring a car into the main part to work on-- thanks for that note. – Reed Hedges Jan 26 '11 at 22:22
  • In very cold environments, batteries in wireless sensors die. We have trouble with outdoor temperature sensors. The safe temperature range for alkaline has a surprisingly high low-end. – Scivitri Jul 15 '13 at 22:27
  • Photoelectric smoke detectors are the recommended way to go these days. Ionization smoke detectors are prone to false alarms and require a small amount of a radioactive isotope in them to function. – hookenz Jul 16 '13 at 0:36
  • This was enlightening. youtube.com/watch?v=zrOLxh8GuCU – hookenz Jul 16 '13 at 0:43
2

I have First Alert Onelink in my home. It has a voice notification that indicates the location of the module activated to all other modules. (I have 4 in my home) There are hard-wired and battery powered units. They also use a photoelectric smoke sensor that reduces nuisance alarms from normal smoke or steam.

I personally don't know about the barn issue or the wireless range; but they have quite a few options among the models on the First Alert site.

1

I wired a remote siren to the smoke detector in our attached shed, so that we will be alerted in the house if there is a fire in the shed. Seven dollar basic smoke alarm, $5.00 piezo from radio shack, some wire, a relay, and an extra 9v battery. It's pretty easy to do.

1
  • Really great answer. Do you have some references on how to build something like this based on your products? – Piotr Kula Aug 10 '12 at 10:11
1

I tested the First Alert Onelink and the Kidde Wireless System side by side for range. I was able to get over 300 feet. The Kidde system is older and is a direct radio link. The First Alert system can 'hop' from detector to detector, so you can form a chain of units each 300 feet apart. Just get two or more units and they talk to each other.

Or: if you get a hardwire unit, you can use the interconnect wire to trigger just about anything (e.g. a garage door opener, siren, radio, alarm system, etc).

Or: get a BRK HD6135FB heat detector (no problem with cold weather or condensation!) and wire it to a OneLink alarm. If the HD6135FB goes off, it activates the OneLink, which relays the message to all linked alarms.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.