enter image description here

enter image description here

enter image description here

I just want to replace it with a new light fitting philips tcg701 but there's way too many wires and I don't know why it was done this way.

  • What region do you live in? That looks like an oddly wrapped ground.
    – Steve
    May 20 '13 at 4:38
  • 1
    If you're not sure what's going on, you might want to contact a local licensed Electrician.
    – Tester101
    May 20 '13 at 11:23
  • The region is NSW. The ground is two grounds from two cables wrapped together with a little strip of green sheeth around it.
    – skybreaker
    May 20 '13 at 12:11

It's fairly standard

enter image description here

In your case the red/white pair is probably from the switch, red probably live and white switched live (normally in my part of the world it would have red tape on it to indicate switched live). The other two twin+earth cables are mains supply and continuation to next light fitting. Your wires were connected directly to the light fitting so there is no separate cable to the lamp.

You can confirm this with vary careful one-handed testing using a suitable Cat II rated mains voltage tester. You can get non-contact voltage testers that make this safer.

After testing and confirming above, I'd connect the new lamp to the black group (AC neutral) and the white wire (switched live)

  • Thank you - not only have you shown me exactly what was going on there but the diagram above shows me exactly how to rewire it for the newer modern light fitting. Thanks!
    – skybreaker
    May 20 '13 at 14:46
  • So basically, three terminals are there to allow daisy-chaining the power, neutral and ground and provide a tap for neutral to the device and power to the switch, and the fourth is a terminal block for the switch. I take it that the Australian system tries to eliminate wire nuts or other extraneous connectors by providing terminals instead? Is this split phase hot/neutral? May 20 '13 at 15:02
  • This diagram is so useful to me - can I ask how you found it?
    – skybreaker
    May 21 '13 at 3:21
  • @skybreaker: I googled "lighting wiring junction" and clicked "images". May 21 '13 at 9:28

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.