0

I want two remove two walls on the second floor a-frame that run perpendicular to the roofline. Some things I've noted:

  • The sliding door when closed blocks the middle point / ridgeline
  • The floor joists in the room run parallel to the wall, however the floor joists switch to perpendicular to the wall once it gets about a foot from the wall (ie. joists are perpendicular where the wall sits)

Thanks for any tips!

yellow lines depict joists

same perspective/direction, but from inside wall on right

opposite side of the wall, looking back

Edit: Update: Started pulling down the sliding door frame and drywall and unfortunately came across a beefy header above the door frame. Looks like this wall is load bearing and would need an engineer to redesign it if I want to proceed.

enter image description here

2
  • Where is the sliding door? Please provide a photo that shows its relationship to the ridgeline. Also, can you check the direction of the roof truss and let us know.
    – r13
    Aug 29 at 16:19
  • The sliding door is inside the wall to the left, in the first photo, behind the orange mountain photo. As for trusses, it's an a-frame and the ridgeline is perpendicular to that wall I want to remove
    – JBlake
    Aug 29 at 16:25
1

My assessment is this is a partition wall that does not carry the roof load, therefore it is removable without adverse effect. However, to be safe, you should invite a structural inspector or engineer to conduct an inspection and advise on the shoring requirement during modification.

enter image description here

4
  • Thanks, I'll give it a shot and use the recip saw trick to see if it binds. But I'm most likely ok!
    – JBlake
    Aug 29 at 18:52
  • 1
    Be prudent, if the wall has been there for a long period, it might have some load in it as the roof and ceiling inevitably settle/deflect a small amount, so shoring is necessary during removal. Good luck.
    – r13
    Aug 29 at 18:57
  • I updated the post with a photo. From my uneducated opinion it looks like I'm SOL until I hire an engineer. At least I have a bigger door opening though and found a dead bird and a hole to the outside of the house on the right side...
    – JBlake
    Aug 29 at 23:02
  • 1
    If I am not mistaken, the last photo shows a bearing wall directly under the roof truss. The roof load is passed to the vertical studs, beside the opening, to the structure below (another wall?), and the load on the opening is carried by the lintel beam to the sistered studs (posts) on the sides of the opening. Watch out, if you want to do anything about this wall.
    – r13
    Aug 29 at 23:23

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.