My cabinet doors are tired and have many coats of ugly paint. Rather than strip all the paint off, I'm considering just chucking the old doors and making new ones. I like the plain style of just a simple, painted rectangle of plywood. But how can I finish the edges of plywood doors to conceal the plies so they don't shout "I am made of plywood"?
You could use MDF. Much cheaper than cabinet grade plywood, and will finish up just fine with paint.
A standard approach on shelving (which works on doors as well) is to glue a solid strip of wood to the edge.
- Use a piece of clear pine (or other inexpensive wood) the same length as the door edge, about 1/4 inch (or more) thick, and a hair wider than the the thickness of the plywood. (You may need to trim down the plywood so the finished size, after edging, fits.)
- Position edge band so it extends a bit beyond each face of the plywood.
- Glue to the edge and either clamp or pin it with a brad gun.
- Once the glue dries, sand the edges flush with the face of the ply.
- "Break" (slightly round off) the outside edges of the solid wood to give it a finished look before painting.
What I have done in the past is routed the edges of the plywood with a round bit, then finish it with sandpaper and seal it with poly and/or stain. While it doesn't hide the layers, it ends up looking pretty good and it is safe. Sort of an industrial look. Just make sure you use a high RPM router with a sharp bit (and wear eye protection).