10

I am thinking of getting a Milwaukee M18 fuel drill/ driver combo. The drill is insane with 750in-lbf of torque. It comes with a hand tighten chuck though. My other Milwaukee corded screwdriver has a key tighten chuck and I like how tight I can get it.

My current drill (very old 9.6v Ni-Cad drill) has a 3/8in hand-tighten chuck. When I drill through steel with this chuck it comes loose. I'm not sure if more modern hand tighten chucks like the one on the M18 are better or not.

If I do get this new drill would it be worth it to get a new chuck, or would the one it comes with be sufficient?

12

I have a hand-tighten chuck on my cordless (a Makita) and I've never had any issues. However most of my bits are spin-resistant (i.e. they have chamfers). I've used it with a step bit to drill 7/8" holes through stainless steel.

If that drill has a user-replaceable chuck, you could always just start with the stock one and upgrade if needed...

9

The drill you refer to has a single-ring chuck that is operated with one arm. Its surface is large enough so that you can have reliable grip and apply enough torque to the chuck to tighten/loosen it in all reasonable situations.

I've used a similar drill of another brand with the same chuck design - the chuck operation and reliability are just excellent. You don't need a keyed chuck instead of this one - a keyed chuck comes with risk of losing the key and with risk of injuring the hand should it slip while tightening.

2

Here is my two cents worth. A lot depends on the particular model and how it is used. My preference is keyless for 3/8" cordless drills and keyed for 1/2".

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.