0

I have a thread cone like this

enter image description here

which I need to load into net needle.

enter image description here

The issue is after I have pulled some thread from the cone, the thread becomes too curly and tangled, it tries to wrap around it self. Is there any easier way to straighten the thread?

2
  • 1
    Sorry, but this isn't a home improvement question. – isherwood Dec 17 '20 at 14:53
  • But, @isherwood, it has the same answer as "how do I keep my wire from kinking when I pull it off the spool"... ;) – FreeMan Dec 17 '20 at 16:44
4

Put the cone on a spindle so it unrolls/unwinds, rather than pulling it off the end.

2
  • It's the only way. – FreeMan Dec 17 '20 at 14:43
  • Show us some of your work :-) – JACK Dec 17 '20 at 14:48

Not the answer you're looking for? Browse other questions tagged or ask your own question.