I bought some cabinet legs along with 90 degree mounting plates from Ebay (I know, what was I expecting)...
2 of the legs are good, threads seated correctly, 1 is a little off but I can live with it; however there is 1 leg that is completely off, so much so that when screwed into the plate it looks like I'd bought the angled versions!
I have made an approximate measurement using photoshop of about 7 degrees off, but attached it seems much more!
My question is: What would be the best way to go about removing and reinserting correctly? I'm assuming the pilot hole will be drilled at right angles.
I have tried getting my pair of needle nose pliers on it as they are the best thing I currently have to hand, but they just appear to slip off. As expected, this is locked in tight :-(
Would it be worth me cutting a notch into the thread to try and get a flat head screwdriver in there?