My little boy flushed a whole lemon down the toilet. It is stuck. What can I use to remove the lemon?
There are attachments for coily drain snakes that have a cork screw type end on them. One example is like this:
Use of such attachment could screw itself into the lemon and allow pulling it out the way it went in.
I'm assuming you're sure that the toilet is blocked by the lemon. Of course it depends on how tightly the lemon is wedged in the toilet. Toilets have a goose neck built into them that serves as a trap to provide a water seal. The lemon is almost certainly in that goose neck.
I don't know of anything safe that will dissolve the lemon that wouldn't be harmful to the toilet, the sewer/septic system and possibly to you. The only good solution I can offer is mechanical.
That involves removing the toilet giving you access to the goose neck from both ends and removing the lemon. It isn't a difficult job but does take some work and know-how. You will need to replace the seal that seals the toilet to the waste line.
The problem with other potential solutions such as pushing it through the goose neck can cause you more serious problems than you have now.
You might want to call a plumber to do this. If you want to do it on your own either I or someone else at this site can help you.
You might want to try Michael Karas' suggestion first. However, be sure to use a toilet-rated auger with the attachment. They have a protective sleeve to keep the auger from damaging the porcelain. Again, good luck.
If you have a shop vac try sucking it back out, removing the 'water' first or just sucking it up too and dealing with the shop vac clean up later. The better the seal of the hose end to the hole in the toilet the better of course. You might try a wet towel as a seal that will conform to fit. This actually might work better if the lemon has a tighter fit as it will create a better seal and therefore more vacuum pressure that can build up so that when/if it releases, it will have some momentum and hopefully come all the way out or at least close enough to reach in and grab it by hand.
A brine solution would suck water out of the lemon by osmosis. This could shrink the diameter enough to make it pass through.
The difficulties with this method are:
- May take days to work.
- Only one side would be exposed to the brine.
- The lemon may have a wax coating to extend shelf life that would slow the process.
- Complete mixing of the salt within the drain would need to be ensured.
By far the safest, fastest, easiest and cheapest method to unblock is to put a single large garbage bag over one hand and see if you can reach the lemon to dislodge it. If it's further down and not directly accessible, you can use your hand to create a plunging action which provides way more push pressure than any hardware-store plunger - you can increase the effectiveness of the plunge by adding toilet paper and filling up the bowl with water so that you have some hydraulic pressure also behind the push. Increase your chances again by adding some dishwasher liquid to make everything slide a bit better.
Dispose of the garbage bag after you've finished with it. For what it's worth this method also works a treat with other common blockages.
Specific to your question of dissolving the lemon - over time the lemon should change shape from dehydration or at least decay enough to dislodge so this should become more effective at later intervals. Just be sure to put an 'out of order' sign on the toilet until it's fixed. Not recommended to use anything caustic as even harsh acids wont actually eat into the lemon itself enough to make a difference and can be dangerous.
For actually dissolving the lemon (or at least enough of it to unclog the drain), ordinary NaOH (lye / caustic soda) based drain opener should work, at least as well as any other reasonably common substance would.
However, since the lemon is whole and presumably intact, it might take a considerable amount of time (as in perhaps days) for the NaOH to work its way through the lemon's skin and pith, which act as natural protective layers. If you can manage to somehow poke a few holes in the lemon's skin, e.g. by sticking a piece of wire down the drain, that should help the process along quite a bit by exposing the soft and acidic flesh of the lemon directly to the NaOH.
(For maximum effectiveness, especially if using solid NaOH powder, pour some hot water in after it to help the NaOH dissolve and react faster. Pre-mixing the NaOH with hot water is also possible, but if you do, make sure to wear proper eye protection while doing so! The dissolution of NaOH in water generates additional heat that could easily make the water boil and splash hot caustic droplets around. If you do get any on your skin or clothes, rinse it off immediately with lots of cold water!)
Note that I haven't actually tested this myself. I do happen to have NaOH and some whole lemons around, so I'm kind of tempted to sacrifice one for science and see how long it takes for the NaOH to start acting on it. I'm not sure it's worth ruining a perfectly good lemon, though.
In any case, physically removing the lemon e.g. using a toilet auger, as suggested in other answers here, is probably much easier and quicker than trying to chemically dissolve it — possibly even if you factor in the time needed to go to a hardware store to buy a toilet auger in the first place. I would only suggest trying chemical methods if the lemon is stuck so deep that you really cannot physically extract it by any practical means.
In this case I would remove the toilet. It may take a little work to get the water out enough to do it but is a far better method than trying to plunge the lemon through. You may require a new wax ring before putting the toilet back on depending on it's condition. Since you are this far, you may also want to replace the bolts that hold the toilet down, again, depending on their condition. This is usually only a few dollars at the local hardware store.
- Shut water off to toilet.
- Empty water from bowl and tank. Use a towel to soak up any excess you're scared might spill.
- Disconnect the water supply.
- Undo the two bolts at the base of the toilet
- Remove toilet.
- Find lemon.
- Remove lemon.
- Re-Install Toilet.
The problem with pushing the lemon through with the plunger would be it getting into your sewer pipes. While a lot of pipes are 3-4" from the toilet it is no guarantee that this is true. Also, different conditions of different pipes (cast iron pipes for example if your house is old enough) could cause restrictions and give you bigger headaches by plugging the main sewer lines in your house; which usually in turn requires a plumber or at the very least, results in a bigger mess.
The worse thing I've ever had to remove from a toilet was a plastic drink cup (more than once) at our community hall. It was enough to plug it, but soft enough you can punch a hole in it with a retriever snake which lets the water go through but renders you unable to retrieve it. Removing the toilet was our only option.
I flushed a lime down the toilet for fun today. I have a toilet auger so I thought it wouldnt be a big deal. It was a big deal. In the end though, the toilet auger did work. It took a lot of brute force and a ton of spinning the augur with pressure applied. I thought I might break something. The toilet was COMPLETELY clogged nothing was getting past this lime.
In the end I was able to pull out the augur which temporarily got stuck, and low and behold it had indeed corkscrewed its way through the lime and impaled it and the lime finally came out with it.
Thus, the augur might not seem to work, or might just want to push the citrus deeper, but enough twirling with pressure applied and elbow greese and you can indeed get it out with an augur.