1

The anchor pictured was holding a hose reel, which has been removed. When I twist the part sticking out it just spins infinitely in either direction. I think it is something like a toggle or a molly anchor. How can anchors of this type be removed with as little damage as possible to the wall?

enter image description here

7

These don't come out easily, sometimes they can be pushed back into the wall and dissappear, this is often the case if the person installing it was thinking ahead and drilled the hole deeper than needed as an end-of-life plan.

Else you need to drive the shaft back in a bit to release the wedge and then pull on the sleeve part, locking pliers are useful here.

If it won't budge the easiest fix is to chop it off using an angle-grinder with a cut-off wheel and then drive it back into the hole a bit and plaster over it.

| improve this answer | |
  • Thank you - I ended up just buying another hose reel of the same type/size and reusing the anchors. Didn't want to deal with these anchors! – Luke Nov 23 '19 at 21:43
2

These are wedge anchors and they're almost impossible to get out withoutY damaging the wall. Your best bet is to use a cutoff tool like a Dremel tool with a cutoff wheel. After removing the bolt portion you can grind away at the sleeve to recess it a bit more and then dab some white caulk around the hole to seal and cover it up. Good luck

| improve this answer | |
  • Masking tape on the surface around your wall anchors will keep burning metal from your angle grinder from staining the surrounding area. – Wayfaring Stranger Nov 22 '19 at 0:49
  • Thanks, if this is the case, I think I'm just going to buy another hose reel of the same size/type. The old one was in bad shape so it looked terrible. – Luke Nov 22 '19 at 1:57
  • @Luke Using brute force , you could screw a nut on the anchor and then grab the anchor with a crowbar. Slide a piece of wood between the wall and crowbar, to protect the wall, and pull. you might just pull the anchor out. this could damage the wall which is hy I didn't include it in my answer. – JACK Nov 22 '19 at 2:55
  • Typically the holes are drilled deeper than needed, after the bolt is cut off, the remaning sleeve and bolt can most likely be driven in to make a wall repair easier, unless you wanted to reuse the hole. This would not be possible in any case. Reusing the bolt as you (Luke) mentioned would be the best solution. – Jack Nov 22 '19 at 3:06
  • 1
    Using a crowbar can get you a hile about 5” in diameter to fill... – Solar Mike Nov 22 '19 at 8:43

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.