1

I have a kitchen outlet that stopped working. I"m in the process of replacing it. I've discarded the old outlet. I purchased a Hubbell duplex receptacle. It has brass screws on the left side with a split circuit tab between them and 2 silver screws with a split circuit tab on the right side.

Do I wire the 2 black wires onto the brass screws and the two white wires onto the silver screws? My test light indicated that only 1 of the black wires is hot.

2
  • 1
    Welcome, James. I get the impression that you are new to house wiring. There are some fundamentals that are important for safety, such as how to create and properly use a wire loop for the screws. I suggest doing some reading of a good how-to book before going further. There's risk involved here.
    – isherwood
    Nov 6, 2019 at 18:34
  • I believe we have a FAQ for that. Was the old outlet not connected that way? Nov 6, 2019 at 18:36

1 Answer 1

4

Yes, wire the black wires to the brass screws and the whites to the silver screws. The black wire that is not hot is feeding a receptacle downstream and being fed by the wire that is hot via the receptacle. Do not remove the tabs on the outlet in this case.

If it's a direct replacement, when in doubt wire the new one the same as the old one and you'll be fine. If you have any doubts as to the connection, post up a few pics.

1
  • 1
    I always like to pigtail these outlets. Good part about going to the screws ( not the backstabs)+
    – JACK
    Nov 6, 2019 at 18:38

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.