We are renovating all the bathrooms in our house that was built in the early 70s.

The plumber has replaced most of the copper pipes with PEX tubing. He has not replaced copper entirely and has coupled copper with PEX (see pics below). He connected the main water supply copper pipes to 1/4" PEX but then connected them to 1/2" PEX later. EDIT: made an error above....should be copper to 1/2" PEX and then connected to 3/4" PEX later. Shouldn't the main supply line be connected to the wider PEX if at all? How does one check that the clamps are properly fixed onto the connectors?

He has run PEX right next to main heating duxt from the furnace in the mechanical room (that supplies heat to the house) and in other places as well. Is this safe? Is a minimum clearance required between the PEX and heat vents?

Please see pictures of the shower rough-ins in two bathrooms. Is it normal to have so many joints and connectors? Any thoughts would be most appreciated.


enter image description hereenter image description hereenter image description hereenter image description hereenter image description hereenter image description here

  • 1
    So many elbows... that pex pipe can be bent neatly with a spring and it will reduce the losses and noise.
    – Solar Mike
    Nov 14 '19 at 7:49
  • Wherever the pipe passes through a stud make sure a mailing protection plate gets added, on both sides if possible. Nov 8 '20 at 12:58
  • I'm sure that wet wall isn't structural, but Oy! those notches! I'm sure it took much longer to cut those than it would have to simply drill a hole...
    – FreeMan
    Mar 8 at 11:57

Great questions! Yeah, I agree that the 1/4" AIN'T RIGHT. Have him replace those sections. A body-spray setup needs all it can get.

Being close to Ductwork is fine, the hot water is hotter than the ductwork will ever get. FYI, the Blue PEX is just coloring and is exactly the same as the Red PEX. However, PEX cannot withstand a furnace flue's/exhaust pipe's temperatures, ensure PEX is not touching nor even within 2' (my requirement) of that Ductwork.

Yes, there is a way to test the Plumber's crimping workmanship. It's a Go/No-Go gauge and he should be using one himself...likely molded/carved onto his crimper. See https://www.menards.com/main/plumbing/plumbing-tools/pex-tools/nibco-reg-go-no-go-pex-crimp-gauge/px01382r1/p-1444449294533.htm

So many fittings? Yep, kind of kills the "PEX advantage", doesn't it...soldering ain't slow and only gets A LOT faster in your kind of shower setup. I'm not a fan of PEX. It's only good for 50-years and copper is good for OVER 100-years (in most areas)...which house would you buy...sell in 20-years or less.

By the way, while you have some access to duct joints, liberally wrap the joints with Aluminum Foil Tape...the real duct tape.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.