I have two coax cables that need to splice together. I am using waterproof F-type connectors but I was wondering if a dielectric grease where the two screw in to each other would be harmful (signal issues, .etc.).
Living and working as a cable television technician in a beachside region, I can attest to the value of the silicone dielectric grease for improving the lifespan of these connections. Salt air eats everything in time, yet the grease prevented corrosion after five years. The fittings were assembled with "boots," rubber covers which resemble spark plug wiring ends. The grease was applied liberally, inside and out, and the boots then slid over the fittings.
Sun, salt, sand and wind would eventually deteriorate the rubber, but even then, the fitting within the mass of grease held up quite well.
I have never used it and am not familiar with the ingredients of that product but generally where RF is concerned you do not want to add something that was not already called for in its application. You said the connectors are water-resistant (water proof is hard but not impossible).
Adding anything at all will introduce performance changes and not for the better (i.e., its not going to boost the signal without active components), it will likely add some filter/tuning impacts but not something you can really control and again, not for the better.
Why add it? Is there a different problem you are trying to solve? If you are aiming for an anti-sieze application, it could work, just read the product label to ensure it doesn't react with the coating or metals used on the connectors and barrels you are using. Use it sparingly on the outer female threads only. Pay mind to avoid the center conductor and the insulator between the threads and the center. Also avoid the very first thread to avoid sandwiching it into the insulator or center connector when tightening it.
Consider STUF dielectric filler, Made for coax, Saw a new video on it : https://www.youtube.com/watch?v=2l0PqZr8-_o&feature=youtu.be