I have a Lennox G14Q3 propane furnace (forced air). I used the Nest/furnace setup last winter without any problems with just the W and R terminals. But, these summer days I would like to push air through the house with the blower (without heat) and remove it with my HRV system.

I’ve tried hooking up the terminal G to the G terminal on the Nest (for the fan). But the Nest can’t seem to turn it on.

Note: When I test the heat with the Nest, my furnace goes through it’s standard cycle of heating up then turning on the blower.

Also, I can’t seem to get the blower going down at the furnace by shorting R and G, shouldn’t that work?

Thanks, Josh

Edit, added model and diagram pictures: enter image description here

enter image description here

EDIT 2: I realized that ACC isn't actually connected to anything. It gets 120VAC when I switch the relay, but there is still no path to the blower to be energized. Could I just take one of the speed wires from the blower motor and connect it to ACC so that it acts as an indoor blower? enter image description here

  • Do you get 120V from ACC to N when you jumper G to R on the furnace? Sep 24 '17 at 13:25
  • Did you re-do the initialization cycle with the Nest where it discovers what kind of heater it's attached to, and what features it has? Sep 24 '17 at 13:25
  • @ThreePhaseEel I get the standard 24VAC between G and R, until of course when I short them.
    – Josh Jobin
    Sep 24 '17 at 13:39
  • @Harper yes, the Nest detected the W, R and G lines. C isn’t connected, but when I did connect it, the Nest didn’t boot. I’ve read that’s because it detects incorrect wiring
    – Josh Jobin
    Sep 24 '17 at 13:40
  • @JoshJobin -- can you measure the voltage from ACC to N while G and R are shorted together? Sep 24 '17 at 13:40

Alright, I figured out why it wasn't working. Had nothing to do with ACC not having a lead. I was looking at my setup closely and noticed that only 2 wires were coming up from the motor, but it needs 3. I noticed that there was a wire coming from pin 3, but it was crimped and didn't run to the motor. So I looked at the speed table and decided I wanted to run the Brown wire up. Connected it to pin 3. Now when I short R and G, the fan turns on :) enter image description here

  • That'd do it :) BTW: you probably should replace this furnace soon -- there's no telling if the previous owners did anything re: the recall, and HX leaks in furnaces are something that's way better to be safe than sorry about. At a bare minimum, I'd have the HX pressure tested ASAP as per Lennox's instructions on the matter. Sep 27 '17 at 22:14

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.