I'm planning on installing a smart dimmer switch but I'm not sure of the best way to connect the neutral wire. The outlet has 3 neutral wires bundled in a push in wire connector. What's the correct way to use neutral wire in this case?

Should I pigtail a new wire into the existing push-in connector or replace it with a wire nut?

Wiring Image

  • Is there a fourth hole on the push-in connector? Also, what make and model of smart dimmer are you planning to install? Jul 20 '17 at 1:53
  • 1
    Twist out the wires, throw the push connector in the trash, and get a wire nut. Jul 20 '17 at 2:59
  • I think there is a fourth hole but I’m not sure about push connectors in general. I’ve always used a wire nut. I’m planning on buying the Leviton smart dimmer.
    – Rachid
    Jul 21 '17 at 6:46
  • 1
    @Harper -- since the connector has a hole spare, there's no need to throw it out (if it was full, I'd agree with replacing it with something that can handle more wires) Jul 21 '17 at 11:33
  • @ThreePhaseEel Push connectors usually have a narrow range of wire size and strandedness which they will permit. Smart switches often use 16AWG wire or even smaller. Jul 21 '17 at 13:28

That type of connector has a fourth hole. I'd use it.

enter image description here

If it didn't, I'd twist out the wires and replace the connector with one of these lever operated connectors:

enter image description here

  • Provided that it's listed for the size of wire he is adding (and strandedness). Jul 21 '17 at 13:25
  • 1
    @Harper. Yes, good point. The one I show is rated pretty much the same as the yellow wire-nut and orange push-in connectors shown already in use in the OP's pic. UL listed for up to 12 AWG solid, stranded or flexible. Jul 21 '17 at 20:35

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.