Ok all i did was i added to the end of the hot and cold water lines about 3 feet of copper line on each hot and cold water to install a washer .I turned off the main but didnt drain the hot water heater just turned off the breaker . added the plumbing and then turned on main and turned on breaker . The washing machine works fine hot and cold water the sink near by works fine also hot and cold water . The problem is there is another bathroom near by and the sink doesnt work now no hot or cold comes out nothing . There is a toilet in that bathroom and it works fine . Why would the bathroom sink no longer get any water ( cold or hot water) .I tryed a couple of times turning main off and on again and nothing . like i said the other sink and washing machine work fine and so does toilet in that bathroom but no water at all comes out of sink hot or cold . And i never shut off angle stops below that sink i never touched it . Any help u can offer will be great thanks for ur time
I assume by angle stops you mean shut off valves. I would back track from the sink. Shut off the valves under the sink and remove the lines. Then slowly open the valves to see if you have water pressure. If not, you're going to have to trace the line back and find the blockage. Obviously take the normal precautions.