I am doing my bathrooms up.

I have tiled up halfway up the wall. I then wanted the tiles to be flush with the wall.

The tilers have suggested;

  • putting a 10mm mdf board (the thickness of the tile) above the tile and painting that. I'm really not a fan of this because i don't believe it will give me the proper finish i am looking for (see the 2nd screenshot)

  • the tiler who finished the finished bathroom said he glued a board 10-15 mm above the tiles. I imagined he then skimmed it and filled in the 10-15mm gap with something, not sure what....

The reason my guys want to use a board and paint that is that the skimming/bonding will make an incredible mess in the bathroom

I need a professionals opinion on how to finish this without a headache in the short term future.

finished look

enter image description here

  • If you don't want to go to all the time and expense and mess to make it flush Just put a decorative border row of tile or bullnose pieces or trim of some sort. Or if you're set on flush Use 3/8 sheet rock But you'll still going to need a transition molding. – Alaska Man May 21 '17 at 23:00
  • 1
    Why do you want it flush? Flush joints are the warts of design. They're usually rather ugly due to the difficult nature of getting everything to come together just right (parallel, on plane). I'd cap with bullnose accents or chair rail like everyone else does and be happy. – isherwood May 21 '17 at 23:06

Tile and drywall is not supposed to be flush. Yours looks a little off because you have not put a row of bullnose tile to round into the drywall.

| improve this answer | |

The only good way I can think of would be to overlay 1/4" drywall and run corner bead along the bottom edge, parallel with the tile edge. You'd need to cut through the existing drywall to allow the corner bead to penetrate, and you may need to rip one face of the bead down to 3/4" to eliminate conflict with wall framing. I'd leave a small gap between the bead and the tile that could be grouted.

Of course, this means a full drywall tape job across the board, and whatever complications result from increased thickness elsewhere on the wall(s).

| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.