6

Can electrical cables be concealed in a fence between two structures? In this residence, the power meters and outdoor panels are located on the garage. There is a panel inside the residence like most places.

In the fence I see three bundles of wires:

  1. Telephone and cable TV
  2. Typical NM like is used inside the walls of a house
  3. Larger cable like is used from a pole to a house normally, probably aluminum.

What seems out of place is that the wiring is concealed in a fence between the structures. I would expect it to be buried or overhead. As it stands, someone attempting to make repairs to the fence could easily drive a nail or screw directly into what appears to be electrical wiring. enter image description here

enter image description here

enter image description here

enter image description here

  • 1
    I believe standard NM cable used in the states is not rated for wet areas. That part is likely against legal. Beyond that, I don't know. – Someone Somewhere May 17 '17 at 5:38
3

Given that the horizontal studs are 1.5 inches deep plus the depth of the vertical planks being .5 inch ( guessing ) total depth is 2". This is a good thing but, and I am going to have to emphasize the but, ..... this is not normal and given the amount and size of wires in there I am not comfortable saying this is okay. But what do I know, I'm only a licensed master electrician who runs his own insured company. ;-)

3

I would not be comfortable with it either - but somehow I think it fails.

There is no protection from nailing and the nail ending up into those wires.

Replacement of the fencing also , personally I think something is amiss. Also there are no warning labels on that fence (that I can see) about high voltage being present.

Did a DIY'er do this to run power to a light pole and also run his cable and TV lines himself ? because you know it is a matter of digging - dollars and time.

Exposed or buried wiring/cable must be listed for its application. Is that wiring listed for its application - is it UM wire ?

Also as an FYI typically a buried cable with no conduit is 12" deep, with RMC 6 inches is acceptable.

What you are seeing for some reason it just smells to me - it might not violate the letter of the code but it is not a normal practice - hence I think a DIY'er perhaps running his own stuff to save $time.

..

  • This is the only source of power to the building. It appears to the original installation, as I can find no indication of conduit in the ground at all. – Eric Urban May 17 '17 at 19:28

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.