Thought my space heater had died when I plugged it in and it wouldn't turn on, not even the "on" indicator light, so I went out and bought a new one. When the new one wouldn't work either, I tested the outlet and a lamp worked just fine. Carried the heater around the house and had no problem with the heater working in other outlets -- just not in the room where I want it!

  • 2
    Are you plugging the lamp and heater into the same outlet in the receptacle? Receptacles are sometimes split, to allow the top outlet to be controlled by a switch while the bottom is always hot.
    – Tester101
    Jan 10, 2012 at 11:59

2 Answers 2


The outlet contacts may be too dirty to carry a heavy load. Or they may be loose. Or the wires to the outlet may be loose either at the outlet or the in the breaker/fuse panel. I would recommend not using this outlet for anything until the point of cause is determined and corrected.

  • 3
    +1, the number one diagnostic step would be to shut the electricity off in that room and open the outlet for inspection.
    – sharptooth
    Jan 10, 2012 at 6:49
  • 2
    The outlet is probably just worn out or the connections bad. just replace it and be done with it. Jan 10, 2012 at 10:40

First, before you open up the receptacle, I would use a power tester (you can get one at the hardware store) to check the voltage and grounding of both sockets. Your heater may have a safety circuit that requires correct wiring/grounding and keeps it from turning on if the socket is incorrectly grounded or wired.

A voltage tester/fault detector will tell you if each socket is wired correctly and if it is grounded correctly. It's not uncommon for some sockets to be wired backwards or for your ground wire to be loose, unconnected, or missing. test each socket, including those that "work" and those that don't and see if there is an obvious wiring fault.

If there is a wiring fault, THEN you can shut off power in the room, take the cover off of the receptacle, and inspect the sockets for damage, loose wires, or incorrect wiring.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.