0

I installed new faucets and used the standard flexible lines for the water connections. I purchased 12 inch lines since the distance between the faucet and the valve is slightly less than 12, but when I installed them, the shorter distance caused a fairly tight bend in the middle and where the mesh meets the connector:

enter image description here

There doesn't seem to be any problems.. yet, but I am concerned about long term wear from having it in this configuration. For this reason, I was going to replace the 12 inch lines for the longest available so I can make a loop, like this:

enter image description here

I wasn't sure, however, if this configuration is actually better since I don't know what kind of bend these things can handle in a practical scenario and whether it is better to have the bend in the pipe, or at the connector. When searching online, most of the information I found simply recommended doing a custom bent steel line if the distance or angle is awkward, but I would rather just take the simpler approach if possible.

Does my first configuration have too much bend in the pipe, and if so, is the looped configuration a better alternative?

Thanks in advance!

Improve this question
2
  • The loop would be more for copper tubing.
    – blacksmith37
    Commented Jul 26, 2018 at 19:47
  • I always buy longer and loop, to prevent stress at the crimped and threaded connections.
    – Jimmy Fix-it
    Commented Jul 27, 2018 at 15:36

1 Answer 1

Reset to default
3

That looks fine. If it concerns you then you can loosen the compression nut on the valve and rotate the orientation of the valve until you have a more gradual bend in the hose.

Improve this answer
1
  • Thank you for the simple, yet effective solution, I was being a little lazy with not wanting to turn off the main water, but that was most certainly a good approach.
    – T James
    Commented Jul 27, 2018 at 14:54

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.