The Stack Overflow podcast is back! Listen to an interview with our new CEO.
2 found a solution
source | link

The faucet runs even when the handles are turned off so I wanted to pull these off and see if I could figure out what is going on...

but I have no idea how to get the faucets off. No visible set screws.

The rings above the conical base pop up then the conical base turns about 2 full revolutions then stops. Is it possible these things are just press on?

EDIT: found the set screws, but it did just slide off. With the ring above the conical part moved, and the conical part screwed all the way down, a small set screw was revealed!

enter image description here

enter image description here

The faucet runs even when the handles are turned off so I wanted to pull these off and see if I could figure out what is going on...

but I have no idea how to get the faucets off. No visible set screws.

The rings above the conical base pop up then the conical base turns about 2 full revolutions then stops. Is it possible these things are just press on?

enter image description here

enter image description here

The faucet runs even when the handles are turned off so I wanted to pull these off and see if I could figure out what is going on...

but I have no idea how to get the faucets off. No visible set screws.

The rings above the conical base pop up then the conical base turns about 2 full revolutions then stops. Is it possible these things are just press on?

EDIT: found the set screws, but it did just slide off. With the ring above the conical part moved, and the conical part screwed all the way down, a small set screw was revealed!

enter image description here

enter image description here

1
source | link

how do I remove this faucet?

The faucet runs even when the handles are turned off so I wanted to pull these off and see if I could figure out what is going on...

but I have no idea how to get the faucets off. No visible set screws.

The rings above the conical base pop up then the conical base turns about 2 full revolutions then stops. Is it possible these things are just press on?

enter image description here

enter image description here