Skip to main content
8 events
when toggle format what by license comment
Jan 31, 2023 at 20:30 comment added Harper - Reinstate Monica @FreeMan Yeah I was just thinking of the vice-grip as a way to add mass to the part you don't want to move. I didn't think about bracing it. Think of it this way: jack up a car wheel so it can spin freely. Try removing the lugs with a ratchet - the tire just spins. But try it with an impact - comes right off! The impact is too short to get the tire spinning.
Jan 31, 2023 at 15:57 comment added FreeMan Huh, interesting, @KMJ. I've always used a #1 or #2 Phillips head and never had a problem with tightening down the cable clamp screws. Yes, you're right, it's the lock ring that I've struggled with.
Jan 31, 2023 at 15:44 comment added KMJ @FreeMan They are specifically fitted to the screws on the clamp. However I misread your comment as being about tightening down the clamp rather than the ring.
Jan 31, 2023 at 12:40 comment added FreeMan In what way, @KMJ?
Jan 31, 2023 at 7:38 comment added KMJ @FreeMan my life got easier when I discovered Xeno screwdriver tips.
Jan 30, 2023 at 21:55 comment added Harper - Reinstate Monica @FreeMan or put a vise-grip on the outside part just to add additional mass to it so it resists rotating in the milliseconds of the impact.
Jan 30, 2023 at 20:10 comment added FreeMan The "bang a flat-blade screwdriver with a <something>" is the technique I've used. I've always had a hard time keeping the wire clamp screws aligned so I can actually reach 'em. I've never tried using one of the little wrenches, though I could see where holding the clamp part with my linesman's pliers to keep it where I want it, then turning the nut with the little wrench could be easier... Maybe I've always tried to make them too tight.
Jan 30, 2023 at 18:03 history answered Harper - Reinstate Monica CC BY-SA 4.0