Skip to main content
Home Improvement

Return to Question

Tweeted twitter.com/#!/StackDIY/status/296151542438957057
deleted 41 characters in body; edited title
Source Link
Niall C. ♦
Niall C. ♦
  • 20.8k
  • 18
  • 95
  • 135

Extending When extending a wrench using a breaker bar, should I connect the two with a spline bit?

Probably dumb question but...

Can iI use my wrench/spanner which has a box end / 12point12-point spline, and connect a breaker bar using a 12-point spline bit 12point to it to get extra leverage.

Or itis it more common to use extending bar/pipe over the wrench? Is

Is the first way possible, iror would the line of torque be off centre/ or-centre? Or would the spline bit / socket connection make this not practical? Thanks in advance.

Extending a wrench using a breaker bar, connect the two with a spline bit?

Probably dumb question but...

Can i use my wrench/spanner which has a box end / 12point spline, and connect a breaker bar using a spline bit 12point to it to get extra leverage.

Or it it more common to use extending bar/pipe over the wrench? Is the first way possible, ir would the line of torque be off centre/ or the spline bit / socket connection make this not practical? Thanks in advance.

When extending a wrench using a breaker bar, should I connect the two with a spline bit?

Can I use my wrench/spanner which has a box end / 12-point spline, and connect a breaker bar using a 12-point spline bit to it to get extra leverage.

Or is it more common to use extending bar/pipe over the wrench?

Is the first way possible, or would the line of torque be off-centre? Or would the spline bit / socket connection make this not practical?

Source Link
weiqimonster
weiqimonster
  • 21
  • 1
  • 2

Extending a wrench using a breaker bar, connect the two with a spline bit?

Probably dumb question but...

Can i use my wrench/spanner which has a box end / 12point spline, and connect a breaker bar using a spline bit 12point to it to get extra leverage.

Or it it more common to use extending bar/pipe over the wrench? Is the first way possible, ir would the line of torque be off centre/ or the spline bit / socket connection make this not practical? Thanks in advance.