Timeline for How to fit a damper in duct?
Current License: CC BY-SA 4.0
6 events
| when toggle format | what | by | license | comment | |
|---|---|---|---|---|---|
| Jan 25, 2021 at 21:54 | vote | accept | amphibient | ||
| Jan 25, 2021 at 17:19 | comment | added | Greg Hill | If there is insufficient room on one side of the duct to admit a drill (ie, it's already installed and can be accessed only from above or below, but not both) then put the paper guide inside the open end of the duct. Drill through the near side and then the far side of the duct by using a 12" or longer cable installers (or "bellhanger") drill bit. | |
| Jan 25, 2021 at 16:50 | comment | added | Kevin Reid | If you make a third dot with the same spacing and wrap the full circumference, you can make sure you got the length right before drilling (when the third dot meets the first). | |
| Jan 25, 2021 at 16:35 | comment | added | FreeMan | Nice answer! Simple, accurate, easy. Great idea. | |
| Jan 25, 2021 at 16:32 | history | edited | Steve Wellens | CC BY-SA 4.0 |
added 25 characters in body
|
| Jan 25, 2021 at 5:48 | history | answered | Steve Wellens | CC BY-SA 4.0 |