1

I recently shut off the whole-house water supply when replacing 2nd floor bathroom sink faucet cartridges because I couldn't get the sink supply line shut off all the way for the hot side to close all the way. I opened the other bathroom sink taps to verify water was truly off and started working.

After maybe an hour, maybe a bit less, water started coming from the open taps of the second sink (which were open), and dripping from the showerhead (which was not). No water came from the faucet on which I was working - though I also had the under sink shutoffs shut.

Why did this happen? Did I just not have the whole-house valve shut all the way? If so, why the delay? Was water just slowly making its way to the 2nd floor? Is there something else going on here that I'm overlooking, like, should have also turned off the supply just to the hot water heater (though the whole-house I thought would trump that)?

All ended up fine, but I'm interested in any ideas why this would have happened.

Thanks.

Improve this question
6
  • questions: how much water came out? was it just a dribble of water or was it flowing at a sustained rate? Did you do something to stop the water, or did it stop on its own? (after how long?)
    – Leo Lansford
    Oct 8, 2018 at 21:36
  • It was a slow but sustained rate from the open sink taps. The shower was a drip though steady, akin to when you switch from faucet to shower or vice versa and the 'last bit' of water drips out. To stop the effect I closed the taps on the sink. Shortly after I turned the whole-house back on and there was no further shower drip.
    – A Barron
    Oct 8, 2018 at 23:09
  • When a valve has not been operated for 10+ years, it tends not to close all the way.
    – Harper - Reinstate Monica
    Oct 8, 2018 at 23:12
  • Thanks @Harper. Would the age of the whole house valve account for the delay between when the water was seemingly totally-off and then started flowing? Perhaps it was only mostly-off (due to age or user error) and then I got most of the water out of the line when I opened the taps, and the rest 'seeped' up over the next hour?
    – A Barron
    Oct 9, 2018 at 0:48
  • Did you open any taps on the first floor?
    – Harper - Reinstate Monica
    Oct 9, 2018 at 0:49

1 Answer 1

Reset to default
1

Okay, we gained more info in the comments, and now the order of events seems clear:

  1. You turned off the water to the whole house,
  2. opened taps on the first floor AND second floor to drain the pipes
  3. closed taps on the first floor and then went to work
  4. after about an hour, the taps on the second floor start to drip

We can now see the reason for the delay: Clearly the 'whole house shutoff' was not completely closed, and the water had to slowly fill all the pipes up to the level of the second floor. If you had left a tap open on the first floor, you would have seen the drip almost immediately.

Improve this answer
1
  • Thanks @Leo Lansford, I thought this might be what happened, always glad when logic matches up with reality.
    – A Barron
    Oct 11, 2018 at 20:15

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.