183 reputation
25
bio website okcthundercast.com
location Oklahoma City, OK
age 37
visits member for 3 years, 7 months
seen Jul 26 '11 at 23:57

Jan
27
awarded  Notable Question
Mar
9
awarded  Notable Question
Feb
22
awarded  Popular Question
Sep
15
awarded  Popular Question
Jul
26
comment New Vanity: Sink Won't Drain Completely
I assume Home Depot or Lowe's would have something to thread on there? How would I add it post-glue? I'm not opposed to cutting this out and doing it again if I need to. I'd rather it be right.
Jul
26
comment New Vanity: Sink Won't Drain Completely
Wow, this is a really detailed answer. Thank you for taking the time to write it out and draw those diagrams. My setup is like figure 3, so theoretically, it should work.
Jul
25
comment New Vanity: Sink Won't Drain Completely
Only the amount of water that should have been in the P-trap came out.
Jul
25
comment New Vanity: Sink Won't Drain Completely
The sink drain had some drips where that threaded area connected to the non-threaded area. That wasn't anything we put together but I threw some putty on it to stop the drip.
Jul
25
comment New Vanity: Sink Won't Drain Completely
It is slightly deeper than the old one, about 2-3 inches. It's also taller. The top of the P-trap was level with the pipe in the wall.
Jul
25
comment New Vanity: Sink Won't Drain Completely
The old drain went into the wall and I don't know where it goes -- we just used what was there and was working. No, there is not an adjustable stopper. It's just a straight drain.
Jul
25
awarded  Supporter
Jul
25
asked New Vanity: Sink Won't Drain Completely
Sep
19
awarded  Student
Sep
19
awarded  Scholar
Sep
19
accepted How do I cut nice mitered corners?
Sep
19
comment How do I cut nice mitered corners?
So, find the angle of the corner, divide by two, and set my saw to that. I'll give it a try. Thanks :)
Sep
19
asked How do I cut nice mitered corners?