3,715 reputation
11236
bio website
location Reno, NV
age
visits member for 2 years, 1 month
seen Aug 15 at 19:42

I love creating elegant software solutions to novel problems.

Data is the future. Optimization is not our enemy.


Apr
11
comment How do I string a low voltage wire between two buildings?
@HenryJackson Yes, I'm fine in that regard.
Apr
11
asked How do I string a low voltage wire between two buildings?
Mar
29
awarded  Popular Question
Mar
26
answered How do I install kitchen cabinets?
Mar
19
awarded  Popular Question
Mar
19
comment Can different gauge wiring be used in the same circuit?
@downvoter, any suggestions on how I can improve my answer?
Mar
19
comment How to remove construction adhesive from concrete?
@shirlockhomes I agree with you, but in the context of this answer: if there's a sure-fire way to gum-up and run through sanding pads quick it's with urethane glues.
Mar
16
awarded  Popular Question
Mar
11
answered How can I attach a sink drain to a drain that is higher than the sink?
Feb
27
comment How can I replace a board in floating wood floor?
I think I understand... Remove the bottom of the groove on the new board, clear the groove on the intact board... Insert the tongue of the new board into the existing groove on the intact board, then set and weight the top-half of the modified groove on the new board?
Feb
27
comment How can I replace a board in floating wood floor?
Do you think the board will be stable with only a single tongue on one side of the board? What will keep it from flapping?
Feb
27
comment How can I replace a board in floating wood floor?
I cannot glue down, this is a floating install.
Feb
27
asked How can I replace a board in floating wood floor?
Feb
25
comment How should I install slab doors when the jamb has been drywalled over?
I imagine you're envisioning something like saloon doors?
Feb
25
comment Can I vent a bathroom fan through the eaves?
+1 for the tip of putting the flex duct insulation over the rigid duct! Also, I agree that it's preferable to exit through the gable or roof.
Feb
25
answered How can I paint both sides of a door without waiting for each side to dry first?
Feb
25
comment Can I use a threaded rod for a rafter tie?
@HerrBag I'd need to measure the angle of the roof for that, and I haven't done so. I was just planning on matching the failure point of douglas fir, since I know it an be used in new-construction for this purpose.... Also I'm not doing every rafter, for 24" OC I can tie every other rafter.
Feb
25
comment Can I use a threaded rod for a rafter tie?
@HerrBag what do you think of HD3B?
Feb
25
comment Can I use a threaded rod for a rafter tie?
@HerrBag I was looking for brackets like that, but that pinch the timber and bolt through.
Feb
24
comment Can I use a threaded rod for a rafter tie?
I was thinking 2" square washers.