595 reputation
414
bio website stackoverflow.com
location Columbus, OH
age 36
visits member for 2 years, 2 months
seen Jul 8 at 17:35

I came, I saw, I conquered.


Oct
13
revised Main 4 inch waste pipe broken
added 4 characters in body
Oct
13
answered Main 4 inch waste pipe broken
Aug
27
comment How can I keep lizards away from my room?
This gave me a good chuckle
Aug
6
awarded  Popular Question
Aug
1
comment What cement board can I use for an outdoor bbq?
What is the intended end finish for the sides? Tile? Stucco?
Jul
31
awarded  Critic
Jun
28
comment How long can I store a bag of Quikrete?
No need to make a special trip. Just make it part of your daily trip to Lowe's :)
Jun
28
answered How long can I store a bag of Quikrete?
Jun
19
awarded  Commentator
Jun
19
comment Can I warm up a swimming pool by submerging black-painted milk jugs in it?
I figured I would post back on here. I made the "lily pads". I ended up having to use a soldering iron to join the black plastic to the hoola hoops. Glue didn't work nor did a laundry iron.
Jun
7
comment How do I remove this kitchen faucet?
This question helped me learn a new word today. Knurled. Thanks!
Jun
3
comment Can I warm up a swimming pool by submerging black-painted milk jugs in it?
Accepting this answer because my question (not what the title was changed too) was for DIY ways to warm up a swimming pool. Upvoted the other answers that were helpful.
Jun
3
accepted Can I warm up a swimming pool by submerging black-painted milk jugs in it?
May
29
awarded  Yearling
May
29
comment Can I warm up a swimming pool by submerging black-painted milk jugs in it?
I should have been more clear. I would cap the jugs after weighing them down enough to sink (probably with sand). I never intended to let chlorine interact with the paint.
May
28
asked Can I warm up a swimming pool by submerging black-painted milk jugs in it?
Feb
1
comment What dangers are associated with changing the pilot light assembly on a gas water heater?
More directly, no I didn't use tape or dope because it wasn't on there before
Feb
1
comment What dangers are associated with changing the pilot light assembly on a gas water heater?
I didn't actually run the black iron pipe as it was already run and the flare nuts didn't have anything like that on them before. I only removed the burner, thermocouple, and pilot light from the control unit. The control unit (with the off/pilot/on dial and temperature control) was already connected and I didn't disconnect that.
Feb
1
comment What dangers are associated with changing the pilot light assembly on a gas water heater?
I used Dawn dish soap which is pretty thin already.
Jan
31
asked What dangers are associated with changing the pilot light assembly on a gas water heater?