993 reputation
721
bio website alertfalse.com
location Mandaluyong, Philippines
age 39
visits member for 4 years, 4 months
seen Oct 25 at 14:39

I'm a community manager and chief [bad] pun officer for Stack Exchange, following two years of service as a community elected moderator on Stack Overflow. Beyond that, I'm:

  • A husband and dad
  • A competent programmer
  • A world traveler
  • Not a teapot, and I have proof!

If you need to reach me, it's tpost shift-2 stackoverflow, but please use this form for common support needs. Note, I do not use services such as Linkedin, please don't try to add me there, it just creates noise.

@tinkertim | ăȘんたら


Sep
26
answered Breakers tripping
Aug
7
answered Is there a keyed switch that can be used to power off a subpanel?
Nov
24
answered Can a Knob & Tube live hot wire be left disconnected without the neutral in a switch box?
Nov
23
answered Is it against NEC code to re-use pulled cable?
Sep
15
answered Why does my receptacle tester say open ground on my new outlet?
Aug
7
answered Can I use indoor Romex in buried outdoor conduit?
Aug
5
answered Is it OK to have 10ga wire running from breaker to switch then 8ga from switch to pump?
Aug
5
answered Is it possible to use a power inverter to run a sump pump?
May
25
answered Can I extend the ground/bus bar in a main service to accomodate subpanel equipment ground?
Mar
16
answered Can I split a 3 wire circuit into 2 separate 2 wire circuits?
Mar
15
answered What is causing the SUPER loud noise from my dryer
Mar
14
answered What is code for installing a dishwasher in the U.S.?
Dec
5
asked How do I find and dispose of the dead body in my ceiling?
Dec
3
answered Can I modify 3 ampere table lamps to work on 5 ampere round pin plugs?
Dec
3
answered Could I use a UPS to power my humidifier on an underrated breaker with a little trickery
Oct
30
answered Correct amps for cooktop and separate oven
May
12
answered What could cause a brand new fluorescent fixture to not work?
May
12
answered Circuit breaker trips every couple of weeks
May
12
answered What's a good way to customize or recess a lightswitch?
Oct
25
answered Why won't the bulbs light even when the fixture is has power?