meta user
network profile
| bio | website | |
|---|---|---|
| location | ||
| age | ||
| visits | member for | 2 years, 9 months |
| seen | 10 hours ago | |
| stats | profile views | 11 |
|
2d |
awarded | Nice Answer |
|
May 15 |
revised |
How can I hang a shelf with no visible fasteners? added 374 characters in body |
|
May 15 |
comment |
How can I use cordless drill batteries in projects? I've done this with the dumb charger that came with my old NiCad batteries but there was basically no circuitry in it. (and it was spare since I replaced it with a smart charger) |
|
May 15 |
answered | How can I hang a shelf with no visible fasteners? |
|
Apr 26 |
comment |
What type of aluminum are squares and 72" straight-edge rulers made of? My local big box hardware store sells extruded aluminum in a variety of shapes. See if they have something that works for you. |
|
Apr 19 |
comment |
How can I mount an 12V transformer for LED lighting inside a wall? At the very least any wiring junction must be accessible so you must have an access panel if you put it inside the wall. |
|
Apr 18 |
comment |
Does it matter if I mix neutrals and grounds in the main panel? The inspector for the work I did was a stickler for having the cables secured like @Tester101 says. Both at the breaker box and every other box. |
|
Apr 16 |
comment |
Is it better to leave the door open or run the fan while showering? Part of the problem may be that with the door closed the fan is not able to pull in fresh air so it is not able to properly vent the room. I say run the fan AND open the door. |
|
Apr 12 |
comment |
How can I create low-cost, fire resistant, hidden in-wall storage? How much depth do you have? It seems even trivial fire resistance would require a pretty thick walls. |
|
Apr 11 |
revised |
Will a Dremel multipurpose bit cut through 1/2 inch polycarbonate? Added note about how I would do it. |
|
Apr 10 |
answered | Will a Dremel multipurpose bit cut through 1/2 inch polycarbonate? |
|
Apr 10 |
comment |
Will a Dremel multipurpose bit cut through 1/2 inch polycarbonate? Straight or curved cuts? |
|
Apr 3 |
comment |
How should I tidy up loose speaker wires? Its too late now but you could have mounted the speaker so the wire passed through the hole in the mount. |
|
Mar 23 |
comment |
How do I best display LED strips so the bulbs are hidden from sight? Where in the room? ceiling? walls? Facing up or facing down. We need more information. |
|
Mar 18 |
comment |
How can I add two bathroom receptacles behind and above a vanity? I thought you could serve receptacles in more than one bathroom with a single 20A bathroom circuit but you could not serve any non-bathroom space. |
|
Mar 18 |
comment |
What is the minimum distance that should be maintained between parallel electric and data cables? I was told a minimum of 12" and if possible when crossing the AC cross at a 90 degree angle. |
|
Mar 18 |
comment |
What is the minimum distance that should be maintained between parallel electric and data cables? @ShoeMaker For high speed data the electromagnetic interference from nearby AC wires can seriously impact the data performance. |
|
Feb 26 |
answered | How should I install slab doors when the jamb has been drywalled over? |
|
Feb 19 |
answered | Should I put a dimmer switch on a ceiling fan? |
|
Feb 6 |
answered | How can I neatly install temperature probes in my ductwork? |
