Reputation
2,662
Top tag
Next privilege 3,000 Rep.
Cast close & reopen votes
Badges
15 55 95
Impact
~540k people reached

  • 0 posts edited
  • 3 helpful flags
  • 130 votes cast
Jan
31
awarded  Famous Question
Jan
21
awarded  Notable Question
Jan
19
awarded  Famous Question
Nov
30
awarded  Famous Question
Nov
16
awarded  Popular Question
Oct
4
awarded  Famous Question
Oct
3
awarded  Popular Question
Sep
24
awarded  Notable Question
Sep
11
awarded  Popular Question
Aug
5
comment How can I center a drill bit so that it drills absolutely straight down rather than perhaps a little off to the side?
What guide did you use to make sure the hole drilled into the wood was straight?
Aug
3
awarded  Popular Question
Aug
3
comment How to drill a groove to the side of a plywood board?
It's difficult to figure out what you're asking. Do you want to drill an actual hole or route a dado/groove? Because you mentioned drill press, this assumes you want to drill a very straight hole. In that case, check out this: amazon.com/Gator-V-DrillGuide-Standard-Portable-Drilling/dp/…. I have one and they're a must-have for straight, accurate drilling if you don't own a drill press. I drilled a 3/8" wide, 4" deep hole right into the edge of a 1/2" sheet of plywood once and the bit went straight in without coming out either side.
Jul
28
awarded  Notable Question
Jul
23
comment Brand New Nail Gun Makes a Dent but No Nails Come Out
I think the dent is just the nail gun's impact against the surface by a combination of either 1) the pressure you're pressing against it and/or 2) recoil
Jul
20
awarded  Popular Question
Jul
14
awarded  Famous Question
Jul
11
awarded  Famous Question
Jul
10
revised How to make my room sound proof
added 31 characters in body
Jul
10
revised How to make my room sound proof
added 122 characters in body
Jul
10
revised How to make my room sound proof
added 252 characters in body