meta user
network profile
| bio | website | blog.tkassembled.com |
|---|---|---|
| location | Los Angeles, CA | |
| age | ||
| visits | member for | 2 years, 4 months |
| seen | Feb 26 at 20:09 | |
| stats | profile views | 8 |
|
Feb 26 |
awarded | Informed |
|
Jan 30 |
accepted | How can I securely fasten a carriage bolt? |
|
Jan 29 |
awarded | Commentator |
|
Jan 29 |
comment |
How can I securely fasten a carriage bolt? Awesome, so basically: Monitor|Hex Bolt|T-Nut|MDF|Washer/Nut|Pipe Fastener|Washer/Nut? Or should the T-Nut go on the other side of the MDF? Should the T-nut have its teeth toward the monitor through the MDF or away from the monitor through the MDF? |
|
Jan 29 |
asked | How can I securely fasten a carriage bolt? |
|
Jan 23 |
comment |
Do 22.5 degree pipe fittings exist? Set screw sounds great, now to find one :) |
|
Jan 23 |
comment |
Do 22.5 degree pipe fittings exist? Only problem would be getting the angle right when gluing the pipes. |
|
Jan 23 |
comment |
Do 22.5 degree pipe fittings exist? Good answer, I hadn't thought of doing that. I could even use 3 90's to keep the pipe lines relatively straight. |
|
Jan 23 |
asked | Do 22.5 degree pipe fittings exist? |
|
Dec 11 |
awarded | Notable Question |
|
Nov 16 |
awarded | Notable Question |
|
Oct 16 |
comment |
What's the least intrusive way to find out what's in a wall? Maybe it's just my terrible luck, but I've always had nothing but problems with stud finders. What I found recently which really worked for me was using magnets to find the nails used to fix the drywall to the studs. Run a magnet up and down the wall and when it sticks, odds are you've found a stud. After that, verify with a stud seeker or with a finishing nail, then hammer away. Any recommendations on a good reliable stud detector? |
|
May 9 |
awarded | Popular Question |
|
Jan 28 |
awarded | Popular Question |
|
Jan 4 |
awarded | Yearling |
|
Nov 4 |
asked | Is there a way to increase toilet flush pressure to prevent clogs? |
|
Nov 4 |
asked | How can I stop a running toilet? |
|
Jul 22 |
comment |
Repair gouges in a particle board desk? That definitely sounds like a good option. I could possibly get veneer strips for the edge and fill in the gap with wood filler. |
|
Jul 22 |
comment |
Repair gouges in a particle board desk? Yeah, and the fact it's on an edge would complicate things a bit as well as since it's particle board and I don't have anything to match the veneer. |
|
Jul 21 |
asked | Repair gouges in a particle board desk? |
