184 reputation
17
bio website geoffreyzheng.wordpress.com
location New York, NY
age 40
visits member for 3 years, 7 months
seen Aug 15 '12 at 2:15

GWT programmer.

Have to use git, prefer hg/mq.

Ex-Java/Swing programmer.

Ex-audio DSP and computer music analysis/synthesis engineer.


Aug
9
awarded  Popular Question
Jun
2
awarded  Notable Question
Apr
18
awarded  Popular Question
Aug
15
accepted How to make a cut-out on an acrylic sheet?
Mar
24
awarded  Popular Question
Aug
22
comment How to make a cut-out on an acrylic sheet?
Is "oversuninstallized" a DIY jargon for "oversized"? Also, would the low-speed jig saw method work for a long and straight cut? I already have some small cracks on the board due to the shitty cutter, so I may as well get a new board and start over.
Aug
21
revised How to make a cut-out on an acrylic sheet?
edited tags
Aug
21
asked How to make a cut-out on an acrylic sheet?
Jul
5
accepted How to install a large mirror on drywall?
Jun
7
comment How to install a large mirror on drywall?
@Alex Feinman: I don't think it's a dup. That question is about a much smaller mirror to hang on the wall, and the accepted answer (clips) definitely doesn't work here. Another answer over there is Liquid Nails, but all require additional support.
Jun
7
asked How to install a large mirror on drywall?
Jun
7
comment How to close a doorway between two apartments?
I found a drywall book in Home Depot with a section showing similar instructions (sans the Good Luck part). Maybe Mr. homes was the author to begin with :)
Jun
7
accepted How to close a doorway between two apartments?
Jun
5
comment How to close a doorway between two apartments?
@Niall C: yes, there were 2 layers of drywall on each side, so in total there were 4 layers. I have a door now.
Jun
5
asked How to close a doorway between two apartments?
Feb
10
comment What kind of drill bit can I use for a small hole on Silestone countertop?
I didn't accept this answer since it's a solution rather than an answer, but it's a much much easier solution, as I'm not handy enough to try the delicate drilling act in the accepted answer. So I bought this piece and it works like a charm!
Feb
10
awarded  Scholar
Feb
10
accepted What kind of drill bit can I use for a small hole on Silestone countertop?
Dec
13
awarded  Supporter
Dec
13
comment What kind of drill bit can I use for a small hole on Silestone countertop?
@Mike: it's replacement and does not fit the location of the old mounting holes.