1,778 reputation
31632
bio website
location
age
visits member for 4 years, 2 months
seen 18 hours ago

Jan
22
accepted How can I unstick my ash dump door?
Jan
21
comment Do I need to clean away WD 40 before I add graphite powder to pram wheel bearings?
The OP will also not have to remove the WD-40 before using the grease.
Jan
21
answered How can I unstick my ash dump door?
Jan
20
asked How can I unstick my ash dump door?
Jan
20
awarded  Notable Question
Jan
13
awarded  Notable Question
Jan
11
comment Replacing shower head - thread sticking out of wall is too long
Does the old escutcheon plate fit the new head? Could you use a generic escutcheon plate? Cheap, probably looks good, and least effort. HTH
Jan
9
comment Did I wire this thermostat properly?
Is there a test procedure that you can follow to make sure all functions work properly?
Jan
8
revised Legal water heater replacement
list formatting, grammar to reach character minimums
Jan
8
suggested approved edit on Legal water heater replacement
Dec
31
awarded  Excavator
Dec
31
revised How can I find a match for ~100 year old door/window trim?
made title more precise
Dec
31
comment How can I find a match for ~100 year old door/window trim?
Pictures of the trim and damage would help.
Dec
31
suggested approved edit on How can I find a match for ~100 year old door/window trim?
Dec
30
comment How to remove this plastic pipe elbow
Any markings or part numbers on it? How much slack in the PEX (plastic) pipe? How far from the PEX to the fixture? You may just need to cut each pipe at the fitting and rerun it. If you have to do that it may be easier to run PEX from the junction shown here all the way up to the fixture instead of the copper.
Dec
3
awarded  Famous Question
Nov
17
awarded  Popular Question
Nov
8
awarded  Famous Question
Nov
4
awarded  Yearling
Nov
3
awarded  Popular Question