New answers tagged bench
I would go further in the event that you want to clamp deep throat clamps or woodworkers clamps. Hand screw clamps can be 6" or more. Keep that in mind for the future. What about a single side with a deeper inset for specialty clamps?
That should generally be enough. If you happen to run into a vise or lamp that wants a little more, you could edge-laminate an additional buffer strip onto the bend in that spot.
First, just a general note - driving lag screws like the one pictured above into concrete or stone would need an anchor drilled and set into the concrete, and you'd also want a washer. If you don't have anchors underneath, you'd probably want a concrete anchor screw or another type of fastener. That said, you'll likely be able to apply more torque with a ...
Top 50 recent answers are included