14
votes
0answers
345 views

What is this velcro-like product?

Does anyone have an idea what this product might be? It was found it on some hired equipment, used as a cable tie / cable tidy. It is reversible and each side will stick to itself, unlike velcro. ...
5
votes
0answers
324 views

What type of rubber pipe is used for this particular installation of hydronic radiant in-floor heating, and is it reliable?

I'm looking at a home built in the 80's with hydronic radiant in-floor heating embedded in concrete slab. I've never seen this type of hydronic tubing before. I'm pretty sure that the attached photo ...
4
votes
0answers
59 views

LP for gas stove

I am trying to hook up a 40# LP tank to my house to supply my gas stove. I have the LP conversion kit installed and piping installed and inspected to the the exterior. Can I just use flexible piping ...
3
votes
0answers
57 views

Should my chimney sit on my roof?

I am renting a house built in the 1940s. The mortar around the brick was cracked causing leaks. Someone had built a chimney around the outside of the original chimney. So outside it's twice the size ...
3
votes
0answers
140 views

How can I move a tub drain plunger, if the linkage chain is missing?

The broken linkage chain was removed from our tub a couple of years ago. All has been good until now the plunger has fallen shut and the water drains v e r y, v e r y s l o w l y. any suggestions how ...
3
votes
0answers
113 views

Why isn't there hot water coming from my faucet after stem replacement?

I just completed the replacement of the hot and cold water stems form my bathtub faucets. The hot water was leaking so I went ahead and replaced both. They were probably original to the house circa ...
3
votes
0answers
227 views

What is a good PWM driver for LED lighting?

I am looking at lighting options for my new flat. I'm looking for any recommendations and suggestions for the components to power and control the LEDs. If we consider the main room (i.e. the open ...
2
votes
0answers
93 views

What kind of toilet tank is this?

This is the toilet tank in my apartment. A few days ago I started noticing brown residue in the water. Upon investigation, I encountered a toilet tank I'm not familiar with... there's an "outer" tank, ...
2
votes
0answers
40 views

How can I match existing mortar?

I'm trying to find a good sand that matches the mortar that I have in our house right now. I live in Chicago. The house is 30+ years old and as I look at the existing mortar, I see that it has large ...
2
votes
0answers
95 views

How does this 50 year old shower valve work?

I'm in a bind, with this valve taken out of the wall and the water supply turned off. It looks like these pieces are all intact, nothing broken. The valve stem screws into what I would call the valve ...
2
votes
0answers
46 views

Can I identify window manufacture from the NAMI information?

All I could find short of removing the window to look for the manufacturer's label is the NAMI sticker information it had inside top frame. And yes I did look through the posted NAMI list here, mine ...
2
votes
0answers
60 views

Is it recommended that 1/8 thick plywood be used as underlayment?

Redoing bathroom floor. After removing tiles and underlayment and linoleum, the floor that's left is decrepit, uneven, wavy, has some old plumbing holes. It is not rotted though, the wood is sturdy. ...
2
votes
0answers
38 views

What should I know before plastering a concrete pool?

These two videos do not make it seem extremely difficult to replaster the pool for, say me and a friend: Swimming Pool Plastering Process (YouTube) Marble Dusting A Pool Also Known As Pool ...
2
votes
0answers
55 views

How many arms should a 5.8m long awning have?

I am preparing to install two awnings with folding aluminum arms. The length of each awning is 5.80 meters or 19 ft. The house is at an elevation of 200 meters or 656ft (in the city outskirts) and ...
2
votes
0answers
46 views

Cement driveway is chipping, what can I fill the holes with?

I have a cement driveway that is chipping. Is there any good options to fill these chipped areas in the cement.
2
votes
0answers
54 views

Front House Posts Not Resting on Anything

I have 5 roof support posts that are supposed to be resting on concrete blocks but one of them is not even touching the concrete block and the other 4 have some separation from the concrete block. ...
2
votes
0answers
38 views

Can sheetrock be put in for fire barrier over existing ductwork and plumbing in drive under garage?

I am in the process of buying a house and the home inspection brought up some interesting issues. The house is in the Atlanta area and was built in 1979 with a drive-under garage. The garage ceiling ...
2
votes
0answers
28 views

How do I add a socket to a fused alarm spur?

I am in the UK. I wish to install a socket (possibly a double) in the under stair area of my house. The main consumer unit is based here and also the alarm box. One option would be to get an ...
2
votes
0answers
91 views

How to remove turn-style tub overflow cover?

I've tried looking all over for a solution, but I've yet to find a solution that matches my situation. The cover I have (I think) is supposed to turn so the hole is downwards so you can remove the ...
2
votes
0answers
138 views

What materials and spacing should I use for ceiling joists/strapping in this conversion?

I have an old two bay garage that's 28'x50', that I would like to convert into a home. One thing I'm trying to figure out is how to do the ceiling. The ceiling is held up by metal joists approximately ...
2
votes
0answers
90 views

Can I repair a shower without pulling everything out?

We had a new shower put in (by a contractor who was in over his head) during a remodel a few years ago. About a year ago the built-in-bench starting to collapse. When we pulled out the bench we ...
2
votes
0answers
25 views

Why does Fix-It-All sometimes dry yellow?

I've used the Fix-It-All brand patching product. Sometimes my patches dry paper white, sometimes they end up yellow. Why might this be?
2
votes
0answers
37 views

How to protect exterior galvanized flashing?

With ships, they'll bolt zinc blocks on, can I "re-galvanize" metal? I ask as I have some flashing that was likely installed in 1938. It was galvanized and is in reasonably good shape. But replacing ...
2
votes
0answers
107 views

When my primer flakes off easily how will it help hold the paint

I'm painting an iron structure to save it from corrosion and make it look nice. I was advised to apply a layer of primer which I did, it contains iron oxide and is supposed to prevent oxidation. Now I ...
2
votes
0answers
204 views

How can I adjust the depth to which a pneumatic toilet flush button must be pressed?

We have a toilet with the cistern built into a cabinet, with a button on the front to flush it. However, it only seems to flush if you press the button right in (quite deep) and you have to do it ...
2
votes
0answers
44 views

How do I use hidden deck fasteners without compromising the integrity of the flashing?

I am using hidden deck fasteners which screw in to the joist and then hold the board via a notch in the side of the board, pretty standard I think. This fastener will sit on the ledger to hold the ...
2
votes
0answers
492 views

Does spray mount adhesive damage the paint on walls after the object attached to it is removed?

I would like to place posters on walls using a spray mount adhesive, such as link to 3M product on amazon. It is said that the use of the adhesive will create a delicate transparent gel on the object ...
2
votes
0answers
150 views

Why would my microwave continually rotate when connected to a voltage stabilizer which is also used for a refrigerator?

When I connected my microwave oven to a voltage stabilizer which is being used for refrigerator,the microwave oven motor starts working without any functions provided.The motor keeps on rotating at ...
2
votes
0answers
145 views

Why won't my pool pump breaker reset?

After extreme rain for a week my pool breaker has flipped off twice and now won't reset. Should I wait for the ground to dry or contact an electrician?
2
votes
0answers
153 views

Is there any advantage to waxing vinyl siding?

My 20+ year old siding can get pretty moldy and grimy in one year. I wondering if waxing it, after I clean it, would help reduce the mold and dirt accumulation and give it new life. I see car waxes ...
2
votes
0answers
48 views

Is it okay to put house wrap over the top of pre-existing foam insulation?

We are removing vinyl siding from our house and replacing it with a cement-type product. Is it necessary to remove the vinyl siding's foam insulation before applying the house wrap?
2
votes
0answers
81 views

Can I add cement glue and sand into my concrete mix to repair my cenent garden statue?

I have a leopard concrete garden statue that was given to me by my neighbor that has a broken foot and log. I want to repair it and paint it. It also has been weather eroded so I need to recover it as ...
2
votes
0answers
138 views

How do I troubleshoot a newly installed non-working outlet?

I recently spent several frustrating hours trying to figure out why an outlet on a new branch circuit would not power a load even though there was proper polarity at the outlet, my non-contact voltage ...
2
votes
0answers
437 views

How do I troubleshoot an intermittent problem with a ceiling light/fan?

We have a ceiling fan that includes a light fixture. One day the light went off several minutes after turning it on. I checked the panel, and found that the breakers were ok. Room receptacles from ...
2
votes
0answers
184 views

How can I insulate and elevate an A/C line set on a flat rubber roof?

The Scenario An apartment building with a flat black rubber roof. The A/C condenser is on a platform on the roof with an air handler inside the unit. The line set runs across the roof for about 20 ...
2
votes
0answers
76 views

Why would the input gas pressure fall when the central heating boiler calls for heat?

Since the annual service of my traditional gas boiler the house takes considerably longer to heat up. The boiler flame no longer seems as "fierce" as previously. I'm told the burner pressure and ...
2
votes
0answers
249 views

How can I wire a bathroom light switch which has an outlet, exhaust fan, and vanity light all from same junction box?

Trying to wire the bathroom light switch, but vanity light will not come back on. There are two wires, black and red, plus a ground wire that wasn't hooked to anything originally just touching the ...
2
votes
0answers
37 views

What's the difference between SFA99 and RIBA Agreements 2010 in the UK?

I am starting the process of having an extension on my house, and getting close to signing an agreement with an architect to have drawings done. The architect would like to use SFA99 as the contract ...
2
votes
0answers
98 views

How can I repair blown plaster on walls?

I live in a very old cottage (1747) some of the plaster mainly on exterior walls has blown/blistered with a powdery residue. We have hacked off the plaster - treated the walls and re-plastered but ...
2
votes
0answers
156 views

How do I level a summerhouse concrete base that dips in the middle?

I laid a 4x3 metre concrete base for my summerhouse/office thing. The corners are all level and so the summerhouse sits fine, but it dips in between and so the load bearing battens aren't taking any ...
2
votes
0answers
371 views

Why does my bath faucet drip for a few minutes after it's shut off?

I have a traditional two handled (one hot and one cold and they are separate) bath faucet. I recently had it reseated and the washers replaced, however, what I noticed was that immediately after shut ...
2
votes
0answers
109 views

What is the cheapest way to make well water with 800ppm TDS suitable for bathing and washing dishes?

I have a 200 foot bore for water in my home. The Total Dissolved Solids (TDS) value of that water is around 790-800ppm. I want to make this water safe for bathing, dish-washing and clothes washing. I ...
2
votes
0answers
102 views

Why aren't my radiators heating up after I replaced a rusted through pipe?

We had a bit of corrosion in an old pipe and it started leaking and losing pressure and so I drained all the central heating system (radiators), replaced the pipe and fitting. It was awkward and the ...
2
votes
0answers
308 views

Is this white powdery substance on a wood shelf caused by flying termites?

There were probably about 100 or 200 so flying termites inside the house two days ago. They were all flying to the ceiling lights, and I placed buckets of water below it and many got in. I also ...
2
votes
0answers
804 views

How can I repair my Bosch dishwasher that won't drain?

My Bosch dishwasher stopped draining. At the end of the cycle, it gets stuck at 1 minute remaining. When I open the door, there's water that hasn't drained. Here's what I've tried: Following the ...
2
votes
0answers
64 views

Should I install the jumper on my new limit control?

I needed to replace fan and limit control (White-Rodgers, model 5D51-35), because the fan switch was broken (fan would constantly run) and heat would not stay on. I took a picture of the control, ...
2
votes
0answers
83 views

Where could the air in the water system be coming from?

We live on the top two floors of a small brownstone walkup. To get the heating to work upstairs I need to bleed the baseboard heater almost every other day. All faucets in the house sputter, and the ...
2
votes
0answers
779 views

What could cause my tankless water heater to make a knocking sound?

I recently replaced my water heater with a tankless unit (Rheem). After installation I noticed that whenever I turned on the hot water; or when my central heating unit would turn on, the tankless unit ...
2
votes
0answers
215 views

How can I fix a table top that I spilled air freshener on?

I spilled air freshener on the top my dining table. It is a veneer top with urethane finish. The area is sticky to touch. How can I fix this?
2
votes
0answers
200 views

Are w1 and w2 both energized during a second stage heat call from the thermostat?

Short version: does two-stage thermostat always close W1 circuit when it closes W2 circuit, or they might be closed independently? Long version: I have two-stage furnace, currently connected to older ...

15 30 50 per page