0
votes
0answers
76 views

Can two circuits feed one sub-panel while remaining separate?

I'm turning a shed into a workshop. I already have two circuits that run to nearby exterior outlets that I want to tie into to power my shed/workshop. I would like to have 1 circuit for lights and the ...
4
votes
1answer
728 views

How to install a electrical outlet box in a workbench?

I'm building a workbench for hobby electronics. I have have my basic blue prints for the bench. I want to install outlets(3-4) along the back of the bench, embedded into the workbench. I want to ...
5
votes
2answers
4k views

How to determine the correct capacity for a sub-panel for a shop?

I plan to install a sub-panel for my woodworking shop, and would like to determine the total capacity that should supply that sub-panel. These are the main items that will likely be running in the ...
5
votes
1answer
972 views

How can I add 100 amp electrical service to a shop?

I am going to wire my shop and want ot run #2 copper to a 100amp breaker panel. I really do not have the space in the 200 amp panel in the house, my question - is there a way to pull this wire off the ...
7
votes
2answers
822 views

Can I plug a workbench mounted double gang outlet into a single gang wall outlet?

I'm thinking about building a workbench on one side of my garage, but I need more outlets for all of my tools. I'm not planning on running everything at once, I just don't want to keep unplugging ...