0
votes
1answer
69 views

Correct Sander Markings on Wood after Stain has properly dried

I re-processed my doors, and got to the third layer of stain. Unbeknownst to me,I had terrible sanding marks in my doors which I can see clearly through the third. Is there anyway to fix this without ...
0
votes
1answer
43 views

When does sanding(smoothing out wood surface) sensibly apply

I know I can smooth surface right after stripping is done. And I read somewhere that I can choose to perform smoothing step after pre-conditioning step instead. What I would like to know is if I can ...
6
votes
6answers
2k views

How to SLIGHTLY widen bored hole in 2x6

I'm making a stand-alone pullup bar and I bored 1 1/4" holes in 2x6's for my 1" galvanized pipe (1 1'4" outside) to slide through. Only the pipe is definitely 1 5/16" (thank you, guy at Lowes) and I ...
5
votes
2answers
1k views

How can I plane the edges of plywood?

I'm working on an 8ft x 12ft climbing wall. I have 3/4 inch ACX plywood attached to a frame. Since the frame isn't perfectly square, the plywood overlaps on the edges (up to about 1cm) so I need to ...
1
vote
3answers
128 views

How to sand wood without flattening it

I'd like to sand some wood planks on a rustic table to remove paint stains, but keep the rough wood structure (1-2 mm height difference). How can I do that?
4
votes
1answer
244 views

What's the significance of orbit diameter in a random orbit sander?

I've been looking at random orbit sanders and noticed that they have different orbit diameters, and some models even offer settings for it. Does the orbit diameter affect material removal, or ...