4
votes
3answers
403 views

As a beginner woodworker, should I buy a table saw or a band saw?

I'm just getting into woodworking and don't have any equipment, not even a bench. As a beginner looking to maybe make anything from small boxes to light furniture, should I buy a table saw or a band ...
2
votes
1answer
151 views

Can a drywall screwdriver be used as a regular power screwdriver?

I will be buying (or renting) a drywall screwdriver, I want to save a bit and have a tool that can be used for woodworking later, can it be used? Is it too low torque (I guess it is about 7 Nm) for ...
9
votes
3answers
361 views

Why do some table saws have a direct and a reverse ruler on the fence?

For example, in the ruler, the bottom row goes from 0 to 31 cm from left to right and the upper row goes from 32 upwards from right to left? EDIT: Here is the manual for the tablesaw pictured ...
11
votes
1answer
216 views

What is the “wobble” adjustment on a jigsaw for?

Every jigsaw I've used had an adjustment knob with an illustration that looked like back-and-forth "wobble" in the blade. What is this adjustment used for? I've always just set it as what I figured ...
4
votes
1answer
150 views

How can I keep a router aligned correctly while running it along the narrow edge of a board?

How can I keep my router aligned correctly when using it with the base against the edge rather than the face of a board? Is there a jig or attachment I should use? Freehanding clearly doesn't cut it.
4
votes
1answer
170 views

What's the significance of orbit diameter in a random orbit sander?

I've been looking at random orbit sanders and noticed that they have different orbit diameters, and some models even offer settings for it. Does the orbit diameter affect material removal, or ...
3
votes
1answer
1k views

Is the 60T blade that came with my Dewalt DWS780 miter good for general purpose cutting?

I recently bought a Dewalt DSW780 12" sliding compound miter saw, along with 60T and 96T diablo blades. My question is, should I keep the blades? Is the 60T blade that came with the saw good enough? ...
7
votes
1answer
942 views

Cutting a Custom Threshold: Best Tool for the Job?

I am in the process of creating a custom threshold to go from a tiled surface down to a carpeted surface. The tile is about an inch above the carpeted floor, so I decided to make a custom threshold in ...
7
votes
2answers
5k views

Can I use an 8“ dado blade set in a 10” table saw?

I have a 10" table saw... this is probably a stupid question, but can I use an 8" dado blade set in this saw? Is one only supposed to use 10" blades in a 10-inch saw? I read on some contractor's ...