2
votes
3answers
222 views

How can I join two pieces of wood at 90 degrees?

I'm trying to make myself a wooden CNC machine. I haven't started on the woodworking yet, as I'm still planning on the easiest way I can construct the machine (newbie here). I'm planning to use 1' x ...
2
votes
1answer
50 views

What is the purpose of the crown in the middle of a router mounting plate?

I purchased a router table mounting plate to go inside a custom made table. The insert includes some crown in the middle of the plate. The height of the crown is roughly 0.030". At fist I thought ...
0
votes
4answers
199 views

What is this technique of joining wood called?

I'm hoping someone can tell me a couple things about how the clipboard pictured below was made. It appears to be three pieces of wood (the same kind of wood), each stained separately, and then joined ...
3
votes
1answer
167 views

When to use a spline vrs a biscuit joiner?

I know how to do either, but want to know if one is better than the other for particular joints (if so, what cases). Or is it just a trade off between time / labor (spline) and ease / cost (biscuit ...
4
votes
3answers
1k views

Are plywood dovetails a good solution to building something that needs to be dismantled?

Are hand cut, plywood dove tails feasible? Assuming you can get "good" plywood, i.e. not the brittle splinter-fest I've seen around, is dovetailing feasible? I'd like to avoid using glue for the ...
7
votes
2answers
1k views

When repairing a split table top, should I use dowels, biscuits, or something else?

We bought a 5' diameter table many years ago from a Macy's warehouse sale. It's a 1" thick wood table top screwed to a cast iron leg/ base. When we bought it, it had a slight warp about 2/3s from ...
2
votes
4answers
162 views

Guidance needed for cutting rabbet

As in this question about making box shelves, I am looking at making some shelves and need some help. I've found this site describing how to make the shelves but need some pointers on what tools I ...