For questions involving wood as a construction material, either as lumber or finished features of a home.

learn more… | top users | synonyms

1
vote
3answers
99 views

Easiest way for non-diy people to link a square wooden post to a wood board?

I might take 3 square wooden posts, about 1.5 meters high, and I need to link them to one or more boards on the bottom, if you propose screws, keep in mind that it has to sit level so they have to be ...
1
vote
3answers
131 views

How can I paint a wooden desk with a rubberised feel?

I've acquired an old wooden desk that is just varnished wood. I would like to paint it but with the rubberised feel I have seen applied to some metals. I'm not sure if this paint exists for wood, but ...
2
votes
2answers
1k views

Will silicone spray lubricant cause bare dry wood to swell?

If wooden parts are binding, will silicone spray lubricant cause bare dry wood to swell? The wood is not maple or oak or birch. It is some type of softwood, maybe fir or pine. The bearing surfaces ...
2
votes
2answers
4k views

How can I repair water-damaged hardwood countertops?

Me and my housemate are complete novices when it comes to home improvement/DIY/etc. so when we moved into a recently renovated house with solid wood worktops, we were oblivious to what care they might ...
0
votes
2answers
114 views

Spilt bleach on stained hardwood floor

Unfortunately upon moving into our new rented flat we have spilt a small amount of bleach (about the size of a large coin) onto hardwood floor. Here is a picture: Is there anything we can do such ...
3
votes
1answer
57 views

How can I protect pine from yellowing?

I have read that pine can begin to yellow very quickly. I am wanting to use pine as an office desk top and want to prevent this yellowing from occurring. Would a oil- or water-based sealant be the ...
2
votes
1answer
43 views

How can I level and finish a slanted deck that was enclosed?

Hello everyone I am new to this so I apologize if I seem a little slow mentally. I have a 104 yr old home that at one point had a deck that was completely enclosed. my issue is that the floor was ...
1
vote
1answer
48 views

What kind of board is this, and where can I get some?

I have some tongue and groove floorboards from a bathroom. They measure 0.83" thick and are probably about 90 years old. Where can I get some boards that are equally thick? Tongue and groove is a ...
1
vote
1answer
64 views

How to remove dried hot glue from a closed door?

Ok so in my room someone used hot glue to close off a small passage way to the attic above. I have searched all over the internet for ways to remove the glue, but none of them seem to work. So ...
1
vote
1answer
285 views

Is this swing beam safe?

Please help. I made a swing for my kids and now am wondering how safe it is. The swing beam is pressure treated yellow pine 4x6 and 16 feet long. The swing hangers are attached to the 4 inch side of ...
1
vote
1answer
314 views

How to fix wood stain drips?

I have recently finished staining some wood 2x4s but I accidentally put too much stain on the wood. It dripped down to the other sides of the boards and it now looks sloppy and tacky. We considered ...
1
vote
1answer
460 views

How can I stain dark Sapele wood to reduce red tone?

I have installed stair treads in Sapele (dark wood with definite reddish tinge) but now realize this clashes badly with the coffee coloured bamboo floor and the oak doors of the hallway where the ...
0
votes
1answer
23 views

Can I paint and polyurethane my plyfloor or does it have to be covered?

On a new build, our subfloor is going to be 18mm plyfloor. I like the idea of painting it with a whitewash and then coating it with polyurethane to keep it as our main floor, rather than covering it ...
0
votes
1answer
61 views

How can I repaint a bad paint job?

I just got a wooden sweet cart made for myself. I asked someone to paint it for me but he did a really bad job. He didn't let paint dry completely so it has smudged all over an looks uneven. How can ...
0
votes
1answer
204 views

How do I install a new header in an exterior load-bearing wall?

I am replacing a 36-inch exterior door with a double door, 6 feet wide. It is going into a studded ground floor wall. There is another story above it. House is 24 feet wide. Assuming I am reading the ...
0
votes
1answer
603 views

How do I prevent interior doors from sticking in the winter?

We have several interior doors that only stick or won't completely close in the winter. We also get cracks in the drywall mud above the doors so I think something else is going on besides just ...
2
votes
0answers
433 views

Is this white powdery substance on a wood shelf caused by flying termites?

There were probably about 100 or 200 so flying termites inside the house two days ago. They were all flying to the ceiling lights, and I placed buckets of water below it and many got in. I also ...
1
vote
0answers
19 views

Calculating Tie Plate loading and double shear

I am considering the use of L strap ties from Strong Tie. I will be connecting two 4x4's in an L-configuration. The image at the very bottom-right corner of the below PDF illustrates exactly the ...
1
vote
0answers
22 views

What should I do before re-painting my skirting boards?

I'll be painting the skirting boards in my room as they are in bad condition. The paint is cracked and the surface uneven and blotchy. What I would like to know is how should I treat the skirting ...
1
vote
0answers
57 views

What can I do if my wood boiler keeps tripping the high limit switch?

I just installed a outdoor wood boiler and added 2nd thermostat in house. When I start wood boiler the high limit switch gets hot and trips. The only way I can keep it going is to put a jumper wire in ...
1
vote
0answers
123 views

What could I be getting stuck on when drilling into a stud?

I was trying to drill a hole for bolts for a TV mount, using a 7/32 bit. About 1" in, the drill wouldn't go any further. It as was in the middle of where my stud finder indicated a stud (but it was ...
1
vote
0answers
103 views

How can I join two beams at a corner post in a historical building?

I am rebuilding a porch on our 200+ year old house. It is in a historic section so I am limited to what materials I can use. The porch is 16' wide by 7' deep. I will have 3 wood posts across the ...
1
vote
0answers
52 views

How can I protect the wall of a simple wooden cottage from rain?

I have newly moved to a property with a small cottage. It is located in a hot desert climate, close to the sea, with occasional rain during the winter. The cottage is made from relatively thin ...
1
vote
0answers
114 views

How should I shut down a woodburner that is attached to an electric furnace for the night?

I have a Monarch Add-A-Furnace wood burner connected by ductwork to my Armstrong Air electric furnace. I use the wood burner when it gets really cold outside, but shut it down at night because I do ...
1
vote
0answers
87 views

How can I repair stacking doors that are not closing properly and running off the track?

I live near a dam. My front entrance runs along a canal Stacked / Folding Wooden Doors I have 4 X 6 pane stacking doors at each of my balconies and I am experiencing the following problems. The ...
1
vote
0answers
39 views

Remove gloss from wood

what is the best way to remove a layer of clear varnish from my garage doors. I need to get them ready for winter and would prefer to stain them but it will not paint over the laquer very well. Sand ...
1
vote
0answers
232 views

Sanding vs power washing vs chemical cleaning wooden deck for restoration

There seems to be various methods for cleaning and preparing a wooden deck for restoration. Some how-to's that I have read strongly advise against power washing. Some sources suggest a combination ...
1
vote
0answers
167 views

I purchased a handmade tool box of unfinished wood with oil and grease stains, I can I clean it up?

I purchased a handmade toolbox, an an auction, made form an old peach crate and old velveta and American cheese boxes for drawers. It was used in a workshop and has oil and grease stains all over it ...
0
votes
0answers
11 views

hydronic baseboard freezing problem

When using a woodstove, the hydronic heating system never kicks on. That can lead to frozen pipes in uninsulated walls. I've heard of Thermogaurd, but its not a smart system, i.e., it uses a timer ...
0
votes
0answers
49 views

How do you match depth of already installed trim?

One of the harder things I have come across when buying houses is making some of the poor craftsmanship, look at least OK. One of the things that keep popping up is when floor trim (and actually this ...
0
votes
0answers
70 views

Can I shave off half an inch of a crowned up 3 by 6" floor joist?

My subfloor is sloping up because of an very crowned up floor joist in the middle of the house. The house is build on footings, and floorconstruction is accessible from underneath. The footings are ...
0
votes
0answers
28 views

What is the width of the expansion gap between solid wood and ceramic tile of equal thickness?

I want to install a T transition between 3/4 inch oak 2 1/4 strip floor and ceramic tile of the same thickness. There is a 1/2 inch wide "tooth" on the bottom of the transition. How wide should the ...
0
votes
0answers
25 views

Poorly applied water based stain - help!

1 week ago I attempted to stain my new deck and did a very poor job. I rushed and over applied and now it is streaky, patchy and uneven. I have read that you can apply stain over the excess areas then ...
0
votes
0answers
54 views

Can a 61-lb speaker sit on a shelf screwed to pine wood paneling mounted directly over masonry?

I'm trying to create more room for guests. If I raise my speakers up, that's 2 more people. But they are 61-pound speakers, and would injure someone if they fell. [So, while not important for ...
0
votes
0answers
60 views

How to restore faded furniture color and sheen

I have a cabinet which is white in color however the white area looks a bit creamy and in some places dirty white. How do I restore the color to what it was when new? Is it possible without ...
0
votes
0answers
52 views

Covering Up A Large Gap In A Wall

I was looking for advice on how could i create a partition between my two rooms which have a huge frame in between them. The place was originally covered by curtains but putting up curtains on the ...
0
votes
0answers
69 views

Span Load for 6x6 PT

Re-doing the deck of an existing bridge that spans 16' for two horses to walk across. The (6) joists are 6x6 pressure treated at 16" on center. Putting 6/4 oak boards on with carriage bolts. Seems ...
0
votes
0answers
52 views

Patio cover advice

I plan to build a patio cover sometime soon. It will be my first large project with lumber. I am primarily a model maker and am looking to expand my skills and expertise. When I moved into the house, ...
0
votes
0answers
60 views

deck repair and painting

the previous owner painted our 1000sf deck but failed to maintain same. Currently the painted deck is peeling and several small areas have dry rot of the wood decking. what is the best way to repair ...
0
votes
0answers
24 views

Can a “tired” tarboard roof be updated without replacing it altogether?

I have a cheaply built wooden cottage in an arid climate with occasional rain during the winter. The roof consists of planks with tarboard nailed on top. The planks appear to be in poor condition ...
0
votes
0answers
77 views

How should I hang two single swings on an apartment patio?

I want to hang two single swings on an apartment patio, side by side. I have an apartment above me, so I know cement is there but it is not a sturdy cover (my ceiling). I want to run a 4 X 4 across ...
0
votes
0answers
990 views

Load bearing capacity of 2x6's for diy lifting cage

I want to build a custom power rack to safely perform heavy barbell exercises in my home. Commercial racks are too tall for my basement. Others have done this before: ...
0
votes
0answers
81 views

How can I pressurize stain into wood?

I'm thinking about how to stain the railing on my deck. What I have is the same design as the last three pictures on this page. I'm going to take the glass out before I stain, so there is some ...
0
votes
0answers
162 views

Wood that can be easily bent

I'm looking for a table of different types of wood, which gives numbers on how bendy they are. Are there any such tables? I ask because I need to decide which veneer I should use to create tight ...
0
votes
0answers
297 views

How do I build a white board stand?

I'm looking to create a wood stand for a white board. I have never built anything before and am looking for both insight on what to do and possible schematic ideas. I took basic construction classes ...
0
votes
0answers
286 views

How to hang shelf on 2cm thin wall?

I would like to somehow saw out a wood board that fits into the corner as seen on the picture below. The problem is that both walls are only 2cm thin. The shelf needs to be able to hold a pair of ...