During a recent remodel, I came across a 3 inch deep by 5 inch wide bottom notch in a 3x10 (the beams are that old!). I must say, i'm just a diy'er and even I was beside myself that someone would do ...
Are hand cut, plywood dove tails feasible? Assuming you can get "good" plywood, i.e. not the brittle splinter-fest I've seen around, is dovetailing feasible? I'd like to avoid using glue for the ...
12'L x 5'D x8'H size aviary needs what thickness plywood to hold human weight. Aviary floor is slightly elevated from the ground. Also, please specify how many floor joists it needs to hold the weight ...
I'm working on an 8ft x 12ft climbing wall. I have 3/4 inch ACX plywood attached to a frame. Since the frame isn't perfectly square, the plywood overlaps on the edges (up to about 1cm) so I need to ...
I'm looking to install false stair treads and risers on my basement stairs. Generally, we're talking about a kit like this: Which is installed with adhesive and finishing nails like this: The ...
I have some applewood 13 ply 3/4" plywood that I'm using for a desk top. I was wondering if I took a router to the edges if it would turnout ok.
I just bought some 1/2" plywood from HD for a project, and the best piece I could find was still pretty warped. Is there a way to fix this? Currently, it's sitting flat on my garage floor with a sheet ...